Philipp Döring

Philipp Döring

Auto-generated profile, based on publicly available information

Philipp Döring

Fraunhofer Institute for Applied Solid State Physics IAF, Freiburg im Breisgau, Germany

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 May 2020 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
JLJana Ligl
Jana Ligl
SLStefano Leone
Stefano Leone
CMChristian Manz
Christian Manz
LKLutz Kirste
Lutz Kirste
PDPhilipp Doering
Philipp Doering
OAOliver Ambacher
Oliver Ambacher
AlScN/GaN heterostructures are worth investigating due to the remarkable high gradients in spontaneous polarization at their interfaces, which brings them into play for a wide field of potential high-power and high-frequency electronic applications. In this work, AlScN/GaN heterostructures for high electron mobility transistor (HEMT) structures were grown by metalorganic chemical vapor deposition. We have investigated the impact of growth parameters on thick AlScN layers and on thin AlScN/GaN heterostructures. Growth parameters, such as temperature, V/III ratio, pressure, and growth mode, were varied with the focus on surface morphology, crystal quality, and incorporation of impurities. High growth temperatures improve the surface quality and reduce impurities incorporation notably. In addition to that, a slight decrease in carbon concentration is obtained by adopting a pulsed supply of metalorganic precursors. V/III ratio and pressure did not influence the layer quality observably. Heterostructures with root mean square surface roughness values as low as 0.38 nm, revealing smooth growth steps, were achieved. The presence of two-dimensional electron gases with sheet carrier densities and mobilities of up to 2 × 1013 cm−2 and close to 900 cm2/(V s), respectively, resulted in channel sheet resistances as low as 337 Ω/sq, very suitable for AlScN/GaN HEMTs. Heterostructures with sheet resistances below 200 Ω/sq and sheet carrier densities of 5 × 1013 cm−2 were also achieved but showed significantly lower mobility.

1 March 2020 in Journal of Crystal Growth
Verified
Journal Article
Closed access
SLStefano Leone
Stefano Leone
RFRoberto Fornari
Roberto Fornari
MBMatteo Bosi
Matteo Bosi
VMVincenzo Montedoro
Vincenzo Montedoro
LKLutz Kirste
Lutz Kirste
OAOliver Ambacher
Oliver Ambacher

3 December 2021 in IEEE Access
Verified
Journal Article
Open access
MBMichael Basler
Michael Basler
RRRichard Reiner
Richard Reiner
Stefan MönchStefan Mönch
Stefan Mönch
FBFouad Benkhelifa
Fouad Benkhelifa
PDPhilipp Doring
Philipp Doring
OAOliver Ambacher
Oliver Ambacher
GaN technology is on the advance for the use in power ICs thanks to space-saving integrated circuit components and the increasing number of integrated devices. This work experimentally investigates a number of key building blocks for GaN power integration. First, an overview of the active and passives devices of the technology is given with focus on area-efficient layouts for power transistors and limitations of on-chip capacitors and inductors with comparison to other IC technologies. Digital and analog basic circuits as part of device libraries are examined and optimized with regard to area-efficiency. The NOT gates have active areas as low as 56.7 μm2 and max. static currents of 0.12 mA with high noise margins. Further digital gates are presented. For the analog circuits, differential amplifiers and voltage reference concepts are presented and compared. Finally, GaN power integration is discussed, and integration levels are defined and described. The GaN technology is compared with other IC technologies, and future challenges and perspectives are shown. GaN power integration based on building blocks aims to exploit the full potential of the lateral GaN technology in order to compete with Si-based IC technologies in the future.

9 September 2021 in IEEE Transactions on Electron Devices
Verified
Journal Article
Open access
PDPhilipp Doring
Philipp Doring
RDRachid Driad
Rachid Driad
RRRichard Reiner
Richard Reiner
PWPatrick Waltereit
Patrick Waltereit
SLStefano Leone
Stefano Leone
OAOliver Ambacher
Oliver Ambacher
In this work, multi-finger current aperture vertical electron transistors (CAVETs) are fabricated with co-integrated high electron mobility transistors (HEMTs). The devices are realized by Mg-ion implantation and metalorganic chemical vapor deposition (MOCVD) regrowth. The intrinsic CAVET design is optimized for robust device performance and applied on multi-finger devices having a total gate periphery of ${W}_{{\text {G}}} =13.5$ mm and ${W}_{{\text {G}}} =77$ mm. Mappings of the transfer characteristics revealed reliable turn-off behavior demonstrating the suitability of the intrinsic device layout. The largest CAVETs revealed a total ON-state resistance of ${R}_{ \mathrm{\scriptscriptstyle ON}} = 1.67\,\,\Omega $ and a maximum drain current of ${I}_{{\text {D},\text {MAX}}} =20.3$ A at ${V}_{\text {GS}} = {3}$ V. A pulse robustness of ${P}_{\text {PULS}} =976$ W at ${V}_{\text {DS}} =50$ V and a pulsewidth of 500 $\mu \text{s}$ is shown without thermal destruction. Additionally, HEMTs are co-integrated on-chip. This combination of HEMTs and reliable large area CAVETs enables the design of high-performance, monolithically integrated GaN power circuits (GaN power ICs) based on the CAVET technology.

25 May 2023 in e-Prime - Advances in Electrical Engineering, Electronics and Energy
Verified
Journal Article
Open access
PNP. Neininger
P. Neininger
MMM. Mikulla
M. Mikulla
PDP. Döring
P. Döring
MDM. Dammann
M. Dammann
FTF. Thome
F. Thome
RQR. Quay
R. Quay

30 November 2023 in IEEE Transactions on Electron Devices
Verified
Journal Article
Open access
PDPhilipp Döring
Philipp Döring
SKSebastian Krause
Sebastian Krause
CFChristian Friesicke
Christian Friesicke
RQRüdiger Quay
Rüdiger Quay
In this work, the simultaneously achievable matching bandwidth and output power of AlScN-based high electron mobility transistors (HEMTs) are derived and compared to conventional AlGaN, GaAs, and Si devices. Moll’s method is used to extract time delays resulting in carrier velocities close to 1 $\times$ 10 $^{\text{7}}$ cm/s for sheet carrier densities $\ge$ 1.5 $\times$ 10 $^{\text{13}}$ cm $^{-\text{2}}$ . Subsequently, theoretical current densities of 2.5–4 A/mm and a maximum transconductance higher than 600 mS/mm are derived for low barrier thicknesses of 5–10 nm and Sc-concentrations of 5%–20%. The matching bandwidth is estimated by the Bode–Fano criterion and connected to the output power of the transistor by the power-bandwidth product, which accounts for both parameters simultaneously. AlScN-based devices are found to exhibit a 4.5-times higher power-bandwidth product compared to conventional AlGaN-based HEMTs, quantifying the enormous, theoretical limits. Experimental data already show an improvement by a factor of 1.45 for AlScN-based devices, even in this early stage of development, which proves their superior properties, when aiming for wideband high-power millimeter-wave (mm-wave) devices.