A mixed oxide support containing Ce, Zr and Al was synthesized using a physical grinding method and applied in the oxidative dehydrogenation of propane using CO2 as the oxidant. The activity of the support was compared with that of fully-formulated catalysts containing palladium. The Pd/CeZrAlOx material exhibited long-term stability and selectivity to propene (during continuous operation for 140 h) which is not normally associated with dehydrogenation catalysts. From temperature-programmed desorption of NH3 and CO2 it was found that the catalyst possessed both acidic and basic sites. In addition, temperature programmed reduction showed that palladium promoted both the reduction and re-oxidation of the support. When the role of CO2 was investigated in the absence of gas-phase oxidant, using a Temporal Analysis of Products (TAP) reactor, it was found that CO2 dissociates over the reduced catalyst leading to formation of CO and selective oxygen species. It is proposed that CO2 has the dual role of regenerating selective oxygen species, and shifting the equilibrium for alkane dehydrogenation by consuming H2 through the reverse water-gas-shift reaction. These two mechanistic functions have previously been considered to be mutually exclusive.
Supported gold nanoparticles are very effective catalysts for the selective oxidation of glycerol which represents an important bio-derived feedstock. In this paper we report that the acid/base properties, especially the acid site density, of these catalysts are the key factor in tuning the selectivity. A range of supported AuPt catalysts have been prepared by sol immobilization using acidic (H-mordenite, SiO2, MCM-41, and sulfated ZrO2) and basic (NiO and MgO) oxides as supports. In particular, using MCM-41 as the support, a high selectivity to glyceraldehyde, an important labile intermediate, was found.
The use of AuPd nanoparticles in catalysis is widespread, with the activity being attributed to their precise structural properties. We demonstrate the restructuring of AuPd nanoparticles under CO oxidation conditions using a combined XAFS/DRIFTS approach. The fresh catalyst exhibits PdO islands at the surface of the nanoparticles, which are reduced under reaction conditions, a process observed via both DRIFTS and Pd K-edge XAFS measurements. From the EXAFS analysis alone the nanoparticles were observed to have a Au rich core with an outer region of intimately mixed Au and Pd atoms. This structure was found to remain mostly unaltered throughout reaction. However, the DRIFTS spectra showed that although Au was present on the surface during the initial stages of reaction the surface rearranged just before light-off, and contained only Pd atoms thereafter. This study highlights the advantage of this combined approach, where both the surface structure and local environment of the constituent metals can be probed simultaneously, allowing a complete picture of the restructuring of these bimetallic particles to be obtained under reaction conditions.
The catalytic performance of a series of 1 wt % Pd/C catalysts prepared by the sol-immobilization method has been studied in the liquid-phase hydrogenation of furfural. The temperature range studied was 25–75 °C, keeping the H2 pressure constant at 5 bar. The effect of the catalyst preparation using different capping agents containing oxygen or nitrogen groups was assessed. Polyvinyl alcohol (PVA), polyvinylpyrrolidone (PVP), and poly (diallyldimethylammonium chloride) (PDDA) were chosen. The catalysts were characterized by ultraviolet-visible spectroscopy (UV-Vis), Fourier transform infrared spectroscopy (FTIR), transmission electron microscopy (TEM), and X-ray photoelectron spectroscopy (XPS). The characterization data suggest that the different capping agents affected the initial activity of the catalysts by adjusting the available Pd surface sites, without producing a significant change in the Pd particle size. The different activity of the three catalysts followed the trend: PdPVA/C > PdPDDA/C > PdPVP/C. In terms of selectivity to furfuryl alcohol, the opposite trend has been observed: PdPVP/C > PdPDDA/C > PdPVA/C. The different reactivity has been ascribed to the different shielding effect of the three ligands used; they influence the adsorption of the reactant on Pd active sites.