9 February 2021 in Journal of Artificial Organs
Chronic blood trauma caused by the shear stresses generated by mechanical circulatory support (MCS) systems is one of the major concerns to be considered during the development of ventricular assist devices. Large multimers with high-molecular-weight von Willebrand factor (VWF) are extended by the fluid forces in a shear flow and are cleaved by ADAMTS13. Since the mechanical revolving motions in artificial MCSs induce cleavage in large VWF multimers, nonsurgical bleeding associated with the MCS is likely to occur after mechanical hemodynamic support. In this study, the shear stress (~ 600 Pa) and exposure time related to hemolysis and VWF degradation were investigated using a newly designed mechanical shuttle shear flow tester. The device consisted of a pair of cylinders facing the test section of a small-sized pipe; both the cylinders were connected to composite mechanical heads with a sliding-sleeve structure for axial separation during the withdrawing motion. The influence of exposure time, in terms of the number of stress cycles, on hemolysis and VWF degradation was confirmed using fresh goat blood, and the differences in the rates of dissipation of the multimers were established. The plasma-free hemoglobin levels showed a logarithmic increase corresponding to the number of cycles, and the dissipation of large VWF multimers occurred within a few seconds under high shear stress flow conditions.
1 January 2021 in Advanced Biomedical Engineering
In traditional Chinese pulse diagnosis, the pulses of bilateral radial arteries are palpated by three fingers. In this study, a device that can objectively perform pulse diagnosis using multiple pressure sensors with a cuff was developed. The device has three pressure sensors in series and a cuff to apply external pressure load. Pulse waves were measured using the non-invasive pulse diagnostic device. The relationship of the data obtained from the proposed system with the diagnosis by the traditional method was examined. The study was conducted with the approval of the Ethics Committee in Tohoku University. Twelve adult male subjects were studied. Data of pulse waveforms recorded from the pulse diagnosis device, electrocardiogram, and continuous blood pressure measured at the fingertip were stored and analyzed. The pulse waves of the subjects were categorized as middle pulse, floating pulse, or sunken pulse according to pulse diagnosis in traditional Chinese medicine. Pulse–waveform data were obtained to measure the pulse–pressure changes, which showed different patterns of the rise time at the three measurement sites. Envelope analysis of the pulse waveform from the middle sensor revealed that the peak value of the pulse pressure increased during calculation stress compared to the resting state. It was possible to measure the pulse waves even when a higher external pressure was applied. Objective pulse-wave measurement using a method similar to that in traditional pulse diagnosis was realized, and pulse waveforms were measured using the proposed pulse diagnosis system.
15 September 2020 in Journal of Artificial Organs
30 July 2021 in Journal of Environmental Engineering (Transactions of AIJ)
Earth-to-air heat exchangers (EAHE) utilize the heat capacity of soil to pre-cool or pre-heat outside air (OA), and then introduce OA into the air handling unit to reduce the heat load of OA. However, at the operational phase, the control of an EAHE is not optimized (e.g., inefficient energy saving or lower quality of introduced air). It is also difficult to establish the optimal control rule that considering the future effects by sequential operations since the control response takes extremely long time. In this study, we focused on the reinforcement learning (RL) control, which does not require the construction of control rules. In RL, an agent learns to maximize reward in the state s within an environment, and this algorithm achieves its purpose by passing action a that maximizes reward to the environment. One of the advantages of RL is maximizing the cumulative reward instead of maximizing the sequential reward. For this reason, RL is suitable for unsteady problems. The purpose of this study is to establish the optimal control rules for an EAHE by RL. In this paper, we validate the RL control rule that achieve the two objectives in which decreasing the heat load of the fresh air handling unit (FAHU) and suppressing the occurrence of condensation in the EAHE. Firstly, we define the control problem for RL using the environment estimated by long-term performance prediction method of EAHEs based on CFD developed by authors. Then, we incorporate training logic to the environment and conduct the training of RL. Secondary, we implement the algorithm for efficient learning by defining rewards as the results of factual and counterfactual actions. Then, we verify the effectiveness of the RL control by comparing the RL control with the scheduled control, etc. Finally, we analyze the tendency of actions selected by RL. The reward is defined by a method of feeding back to the actions selected by the Agent to the relative rewards. This method compares and evaluates not only the results of factual action but also the results of counterfactual action based on the Counterfactual Predictor. This makes it possible to give immediate feedback to the Agent which action was appropriate. We call this method Factual and Counterfactual Reward Estimation (FCRE). As a result of RL using FCRE, it is possible to obtain rough policy in the early stages of the learning and high convergence of learning. Comparing the RL control with the scheduled control, heat load of FAHU is increased about 3%, but the occurrence of the condensation is extremely decreased by the RL control. It was confirmed that it is possible to control to achieve the above two objectives simultaneously by the RL control.