Centro de Investigación y Desarrollo Tecnológico en Electroquímica (CIDETEQ). Parque Tecnológico Sanfandila, Pedro Escobedo, A.P. 064, C.P. 76703, Querétaro, México
Auto-generated profile, based on publicly available information
Abigail González-Zea
Centro de Investigación y Desarrollo Tecnológico en Electroquímica (CIDETEQ). Parque Tecnológico Sanfandila, Pedro Escobedo, A.P. 064, C.P. 76703, Querétaro, México
This work presents the design, fabrication, and testing of a circular split ring resonator (Cir-SRR) with an embedded interdigital capacitor (IDC) for emerging contaminant detection. The IDC attached to the outer ring gap of the Cir-SRR concentrates the electric field and improves the sensitivity of the resonator. According to measurements, the IDC/Cir-SRR resonates at 1.77 GHz and achieves a quality factor Q of 295. The simulation reported a hot spot of 115.9204 dBV/m in the IDC detection zone. The resonant frequency shifts approximately 400 MHz when the liquid sample changes from water to ethanol. The sensitivity was studied using ethanol in deionized water. An average sensitivity of 1.53% was achieved in the relative permittivity range of 18–79. Triclosan and glyphosate were selected as emerging contaminants and were tested by dissolving them in a 50% ethanol-water mixture and water, respectively. Linear relationships between the S21 transmission parameter and concentration were found in the selected ranges of 0–50 μg/mL and 0–35 μg/mL for triclosan and glyphosate, respectively. A sensitivity of 6.87×10-2 dB/(μg/mL) and a limit of detection (LOD) of 1.83 μg/mL were obtained with glyphosate solutions. In contrast, the values of 1.47×10-2 dB/(μg/mL) and 1.18 μg/mL were obtained with triclosan solutions. The results suggest that this technology offers a viable approach for the rapid detection of emerging water contaminants.
NiB thin films, owing to their optical, chemical, and electrocatalytic properties, are promising for renewable energy applications such as water splitting, electrocatalysis, and energy storage. In this study, NiB thin films with varying boron (B) contents (Ni–B(x wt%), x = 0.84, 0.96, 1.06, 1.17) were electrodeposited on fluorine-doped tin oxide (FTO)-coated glass substrates using solutions containing different concentrations of borane dimethylamine as the B source. The morphology and chemical composition of the films were analyzed using scanning electron microscopy (SEM), glow discharge optical emission spectroscopy (GD-OES), and X-ray photoelectron spectroscopy (XPS). SEM images revealed hemispherical clusters whose size decreased with increasing B content. Multifractal analysis of the SEM data further confirmed that surface complexity increased as the B content rose. Optical characterization using UV–Vis diffuse reflectance spectroscopy showed visible-light absorbance, with band gap values from 2.31 to 2.43 eV. Open-circuit potential and Mott–Schottky analyses confirmed the p-type semiconducting nature of all films. Photoelectrochemical measurements, including photopotential and Linear scan voltammetry, showed enhanced photocurrent with increasing B content. The Ni–B(1.17 wt%) film exhibited the highest photocurrent density demonstrating its superior photoelectrochemical performance and confirming the positive impact of boron enrichment on the films’ semiconducting and photoelectrocatalytic properties.