Zinc oxide layers on soda-lime glass substrates were fabricated using the sol-gel method and the dip-coating technique. Zinc acetate dihydrate was applied as the precursor, while diethanolamine as the stabilizing agent. This study aimed to determine what effect has the duration of the sol aging process on the properties of fabricated ZnO films. Investigations were carried out with the sol that was aged during the period from 2 to 64 days. The sol was studied using the dynamic light scattering method to determine its distribution of molecule size. The properties of ZnO layers were studied using the following methods: scanning electron microscopy, atomic force microscopy, transmission and reflection spectroscopy in the UV-Vis range, and the goniometric method for determination of the water contact angle. Furthermore, photocatalytic properties of ZnO layers were studied by the observation and quantification of the methylene blue dye degradation in an aqueous solution under UV illumination. Our studies showed that ZnO layers have grain structure, and their physical–chemical properties depend on the duration of aging. The strongest photocatalytic activity was observed for layers produced from the sol that was aged over 30 days. These layers have also the greatest porosity (37.1%) and the largest water contact angle (68.53°). Our studies have also shown that there are two absorption bands in studied ZnO layers, and values of optical energy band gaps determined from positions of maxima in reflectance characteristics are equal to those determined using the Tauc method. Optical energy band gaps of the ZnO layer fabricated from the sol aged over 30 days are EgI = 4.485 eV and EgII = 3.300 eV for the first and second bands, respectively. This layer also showed the highest photocatalytic activity, causing the pollution to degrade 79.5% after 120 min of UV irradiation. We believe that ZnO layers presented here, thanks to their attractive photocatalytic properties, may find application in environmental protection for the degradation of organic pollutants.
An increasing percentage of ethanol in fuel leads to significant changes in polarity and solubility, which makes conventional gasoline deposit control additives (DCAs) difficult to dissolve in ethanol fuels, resulting in the formation of deposits on engine elements. Critical areas of deposit formation in an engine are constituted by inlet valves, combustion chambers, and fuel injectors. As a consequence, operational parameters of the engine are disturbed to a large extent by the total effect of the deposits. To prevent the aforementioned phenomena, in the operation of engines fueled with ethanol-containing blends, it is necessary to use specifically prepared DCAs. The paper briefly presents a process of development of DCAs dedicated to high-ethanol fuels. Each of the prepared DCA formulations contained a substance having detergent-emulsifying properties (referred to in the text as DEM), a carrier oil, and a solvent. The composition and ratios of components used in the DCA, by testing their effectiveness in engine deposit formation, are verified. A motor station and a test procedure developed for this purpose were used. In search of alternative solutions to conventional polyisobutyleneamines (PIBA) and polyetheramines (PEA) surfactants, which have good solubility in hydrocarbons but not in ethanol, a substance with a benzoxazine structure and a Mannich base were synthesized. Their chemical structures were confirmed by nuclear magnetic resonance (NMR) DCAs were developed, and the effectiveness of their action was verified. Moreover, attention was paid to the dosage level of the DEM and the carrier oil in the DCA. Finally, it was confirmed in the studies carried out that DCAs used for improvement of conventional hydrocarbon engine gasolines are not efficient enough when used in E85 fuels. In the case of the latter, DCAs that have been specifically developed for such fuels should be used, because they have a different chemical structure, and are soluble in the ethanol-gasoline mixture in any ratio of both components.
1 December 2016 in Applied Catalysis B: Environment and Energy