Crack-free binary SiOx:TiOy composite films with the refractive index of ~1.94 at wavelength 632.8 nm were fabricated on soda-lime glass substrates, using the sol–gel method and dip-coating technique. With the use of transmission spectrophotometry and Tauc method, the energy of the optical band gap of 3.6 eV and 4.0 eV were determined for indirect and direct optical allowed transitions, respectively. Using the reflectance spectrophotometry method, optical homogeneity of SiOx:TiOy composite films was confirmed. The complex refractive index determined by spectroscopic ellipsometry confirmed good transmission properties of the developed SiOx:TiOy films in the Vis-NIR spectral range. The surface morphology of the SiOx:TiOy films by atomic force microscopy (AFM) and scanning electron microscopy (SEM) methods demonstrated their high smoothness, with the root mean square roughness at the level of ~0.15 nm. Fourier-transform infrared (FTIR) spectroscopy and Raman spectroscopy were used to investigate the chemical properties of the SiOx:TiOy material. The developed binary composite films SiOx:TiOy demonstrate good waveguide properties, for which optical losses of 1.1 dB/cm and 2.7 dB/cm were determined, for fundamental TM0 and TE0 modes, respectively.
An increasing percentage of ethanol in fuel leads to significant changes in polarity and solubility, which makes conventional gasoline deposit control additives (DCAs) difficult to dissolve in ethanol fuels, resulting in the formation of deposits on engine elements. Critical areas of deposit formation in an engine are constituted by inlet valves, combustion chambers, and fuel injectors. As a consequence, operational parameters of the engine are disturbed to a large extent by the total effect of the deposits. To prevent the aforementioned phenomena, in the operation of engines fueled with ethanol-containing blends, it is necessary to use specifically prepared DCAs. The paper briefly presents a process of development of DCAs dedicated to high-ethanol fuels. Each of the prepared DCA formulations contained a substance having detergent-emulsifying properties (referred to in the text as DEM), a carrier oil, and a solvent. The composition and ratios of components used in the DCA, by testing their effectiveness in engine deposit formation, are verified. A motor station and a test procedure developed for this purpose were used. In search of alternative solutions to conventional polyisobutyleneamines (PIBA) and polyetheramines (PEA) surfactants, which have good solubility in hydrocarbons but not in ethanol, a substance with a benzoxazine structure and a Mannich base were synthesized. Their chemical structures were confirmed by nuclear magnetic resonance (NMR) DCAs were developed, and the effectiveness of their action was verified. Moreover, attention was paid to the dosage level of the DEM and the carrier oil in the DCA. Finally, it was confirmed in the studies carried out that DCAs used for improvement of conventional hydrocarbon engine gasolines are not efficient enough when used in E85 fuels. In the case of the latter, DCAs that have been specifically developed for such fuels should be used, because they have a different chemical structure, and are soluble in the ethanol-gasoline mixture in any ratio of both components.
1 December 2016 in Applied Catalysis B: Environment and Energy