Heavily Si-doped GaN layers grown by pulsed sputtering deposition (PSD) on Fe-doped GaN/Al2O3 templates are investigated using infrared reflectance and microscopic Raman measurements. The electron densities (ne) of the Si-doped layer are found to be in the range of 3 × 1018–4 × 1020 cm−3. Signs of transition to over doping is detected for the highest-doping sample by exploiting the advantages of infrared reflectance and microscopic Raman scattering measurements, where we observe a gradual decrease in ne and the highest broadening of the Raman peak of the E2(high) phonon mode toward the surface, and also growing of an additional Raman peak toward the surface, which is attributed to the generation of cubic phase crystal. On the other hand, other samples show spatially uniform ne up to 2 × 1020 cm−3 and small strain in the whole region in the Si-doped layers. This result demonstrates the growth feasibility of highly conductive Si-doped GaN layer by the PSD method.
We have grown high-crystallinity InGaN layers on ScAlMgO4 (SAM) substrates using metalorganic vapor-phase epitaxy. We have prepared atomically flat SAM substrates by cleaving them along the c-plane and have utilized direct InGaN growth without any low-temperature buffer layer. The resulting InGaN layer has a distinct hexagonal hillock morphology and remarkable crystalline quality. The x-ray rocking curve measurements showed that (000 ) and (10–1–2) peaks full widths at half-maximum are as good as 384 and 481 arcsec, respectively. The calculated threading dislocations densities are as low as 2.9 × 108 and 1.6 × 109 cm−2 in the case of screw-type and edge-type dislocations, respectively.
28 June 2022 in Materials Science in Semiconductor Processing
The anisotropic strain characteristics of semipolar (112¯2) AlN grown on m-plane sapphire were investigated by Raman spectroscopy and high-resolution x-ray diffraction. The Raman quasi-TO mode exhibited a systematic asymmetry in the line shape, which was quantified by the asymmetry factor β using bi-pseudo-Voigt fitting. XRD analysis of multiple diffraction planes confirmed the presence of anisotropic strain in the films. A monotonic correlation was found between β and the anisotropic strain parameter (εaa−εam) derived from XRD. These results suggest Raman β-factor analysis can serve as a practical, nondestructive indicator of anisotropic strain in semipolar (112¯2) AlN.