Here, we report highly efficient InGaN-based red light-emitting diodes (LEDs) grown on conventional c-plane-patterned sapphire substrates. An InGaN single quantum well active layer provides the red spectral emission. The 621-nm-wavelength LEDs exhibited high-purity emission with a narrow full-width at half-maximum of 51 nm. The packaged LED’s external quantum efficiency, light-output power, and forward voltage with a 621 nm peak emission wavelength at 20 mA (10.1 A/cm2) injection current were 4.3%, 1.7 mW, and 2.96 V, respectively. This design development represents a valuable contribution to the next generation of micro-LED displays.
We report the characterization of a N-polar InGaN layer deposited by metalorganic vapor-phase epitaxy on a ScAlMgO4(0001) (SAM) substrate without a low-temperature buffer layer. The InGaN layer was tensile-strained, and its stoichiometry corresponded to In0.13Ga0.87N. We also present the microstructural observation of the InGaN/SAM interface via integrated differential phase contrast-scanning transmission electron microscopy. The results show that the interface between N-polar InGaN and SAM occurs between the O atoms of the O–Sc SAM surface and the (Ga,In) atoms of InGaN.
We have grown high-crystallinity InGaN layers on ScAlMgO4 (SAM) substrates using metalorganic vapor-phase epitaxy. We have prepared atomically flat SAM substrates by cleaving them along the c-plane and have utilized direct InGaN growth without any low-temperature buffer layer. The resulting InGaN layer has a distinct hexagonal hillock morphology and remarkable crystalline quality. The x-ray rocking curve measurements showed that (000 ) and (10–1–2) peaks full widths at half-maximum are as good as 384 and 481 arcsec, respectively. The calculated threading dislocations densities are as low as 2.9 × 108 and 1.6 × 109 cm−2 in the case of screw-type and edge-type dislocations, respectively.
Here, we explore a catalyst-free single-step growth strategy that results in high-quality self-assembled single-crystal vertical GaN nanowires (NWs) grown on a wide range of common and novel substrates (including GaN, Ga2O3, and monolayer two-dimensional (2D) transition-metal dichalcogenide (TMD)) within the same chamber and thus under identical conditions by pulsed laser deposition. High-resolution transmission electron microscopy and scanning transmission electron microscopy (HR-STEM) and grazing incidence X-ray diffraction measurements confirm the single-crystalline nature of the obtained NWs, whereas advanced optical and cathodoluminescence measurements provide evidence of their high optical quality. Further analyses reveal that the growth is initiated by an in situ polycrystalline layer formed between the NWs and substrates during growth, while as its thickness increases, the growth mode transforms into single-crystalline NW nucleation. HR-STEM and corresponding energy-dispersive X-ray compositional analyses indicate possible growth mechanisms. All samples exhibit strong band edge UV emission (with a negligible defect band) dominated by radiative recombination with a high optical efficiency (∼65%). As all NWs have similar structural and optical qualities irrespective of the substrate used, this strategy will open new horizons for developing III-nitride-based devices.
Here, we report the first demonstration of a full InGaN-based red LED grown on a c-plane ScAlMgO4 substrate. This work represents a potential approach for achieving red emissions from an InGaN quantum well grown on InGaN underlying layers. The LED device exhibits a peak wavelength of 617 nm at a current injection of 40 mA (10.5 A cm−2). The light output power and external quantum efficiency were 12.6 μW and 0.016% at 40 mA (10.5 A cm−2), respectively. These results are expected to contribute to the development of longer-wavelength emission LEDs and laser diodes.