Cotton fibres of high Micronaire values are known to have inferior spinning performance. Either reduction of fibres’ fineness or increase in tensile strength is generally expected to improve the spinnability of fibres. In this piece of research, the effects of alkali treatment at lower concentrations (0.75–2.25M) and higher temperatures (70–100 °C) on the cross-section of cotton fibre and on the tensile strength have been investigated. Observations were made using scanning electron microscopy (SEM) and single fibre tensile strength testing. It was found that the roundness of the fibre cross section was improved and the tensile strength of the fibres also increased after treatment with alkali at lower concentration (0.75 M) and relatively lower temperature (70 °C). It is proposed that such changes occurred due to possible cellulose dissolution/transformations. It was thus concluded that the alkali treatment of cotton fibres at lower concentrations (0.75 M) and 70 °C for a shorter period of time (45 mins) could lead to improvement in tensile strength and roundness of fibre cross-section, thereby improving micronaire.
The effective thermal conductivity and air permeability of a multifilament polyester yarn used in sports T-shirts was investigated by computer modeling using finite element analysis. It has been shown that the number of fibers, the porosity of the yarn and the proportion of fibers in the volume fraction of the yarn have a direct effect on the effective thermal conductivity and air permeability of the multifilament yarn. It was found that with the increase in the number of fibers, the porosity of the yarn decreases linearly, while the volume fraction of the fibers increases, and thus the effective thermal conductivity increases. In addition, air permeability decreases exponentially.
Purpose: The purpose of this study is to investigate the utility of carbon black containing coating formulations that are conventionally used for pigment printing of textiles in fabricating electrically heated fabrics. Design/methodology/approach: Specifically, electrical and thermal characterisation of the coating system was carried out to establish the feasibility of the system for use in the manufacturing of flexible heating elements on textile substrates. The coating formulations were applied via a simple padding technique followed by stitching the electrodes using a conductive yarn. Findings: The heating elements of different sizes thus produced showed Ohmic behaviour as a resistor and attained a targeted temperature difference of up to 40°C within the applied voltage range. A prototype heater was also produced, and thermography results showed uniform heating and cooling of the heater that was incorporated into a jacket. Originality/value: The proposed method is envisaged to be very practical for the realisation of completely textile-based heating elements of different shapes and sizes. Furthermore, the proposed manufacturing method can be used to convert conventional ready-made articles of clothing into heated textiles for various applications.