17 June 2022 in Chinese Journal of Aeronautics
2 February 2011 in Science China Technological Sciences
1 January 2008 in Shock and Vibration
A composite high-aspect-ratio wing of a high-altitude long-endurance (HALE) aircraft was modeled with FEM by MSC/NASTRAN, and the nonlinear static equilibrium state is calculated under design load with follower force effect, but without load redistribution. Assuming the little vibration amplitude of the wing around the static equilibrium state, the system is linearized and the natural frequencies and mode shapes of the deformed structure are obtained. Planar doublet lattice method is used to calculate unsteady aerodynamics in frequency domain ignoring the bending effect of the deflected wing. And then, the aeroelastic stability analysis of the system under a given load condition is successively carried out. Comparing with the linear results, the nonlinear displacement of the wing tip is higher. The results indicate that the critical nonlinear flutter is of the flap/chordwise bending type because of the chordwise bending having quite a large torsion component, with low critical speed and slowly growing damping, which dose not appear in the linear analysis. Furthermore, it is shown that the variation of the nonlinear flutter speed depends on the scale of the load and on the chordwise bending frequency. The research work indicates that, for the very flexible HALE aircraft, the nonlinear aeroelastic stability is very important, and should be considered in the design progress. Using present FEM software as the structure solver (e.g. MSC/NASTRAN), and the unsteady aerodynamic code, the nonlinear aeroelastic stability margin of a complex system other than a simple beam model can be determined.
11 July 2012 in Science China Technological Sciences
12 May 2019 in International Journal of Aerospace Engineering
This paper describes a framework for an active control technique applied to gust load alleviation (GLA) of a flexible wing, including geometric nonlinearities. Nonlinear structure reduced order model (ROM) and nonplanar double-lattice method (DLM) are used for structural and aerodynamic modeling. The structural modeling method presented herein describes stiffness nonlinearities in polynomial formulation. Nonlinear stiffness can be derived by stepwise regression. Inertia terms are constant with linear approximation. Boundary conditions and kernel functions in the nonplanar DLM are determined by structural deformation to reflect a nonlinear effect. However, the governing equation is still linear. A state-space equation is established in a dynamic linearized system around the prescribed static equilibrium state after nonlinear static aeroelastic analysis. Gust response analysis can be conducted subsequently. For GLA analysis, a classic proportional-integral-derivative (PID) controller treats a servo as an actuator and acceleration as the feedback signal. Moreover, a wind tunnel test has been completed and the effectiveness of the control technology is validated. A remote-controlled (RC) model servo is chosen in the wind tunnel test. Numerical simulation results of gust response analysis reach agreement with test results. Furthermore, the control system gives GLA efficacy of vertical acceleration and root bending moment with the reduction rate being over 20%. The method described in this paper is suitable for gust response analysis and control strategy design for large flexible wings.