17 June 2022 in Chinese Journal of Aeronautics
1 January 2021 in Shock and Vibration
In recent years, there has been widespread interest in the design of microair vehicles (MAVs) for flapping flight with high‐aspect ratio wings due to their high efficiency and energy savings. However, the flexibility of a flapping wing causes the aeroelastic effect, which remains a subject of investigation. Generally, existing research simulates active bending and twisting of flexible wings under the assumption of neglecting flapping inertia. In this research, the kinematic optimization of a bionic wing with passive deformation in forward flight while undergoing flapping and pitching is considered. To this end, a computational aeroelasticity framework, which includes the three‐dimensional unsteady vortex lattice method (UVLM) and the Newmark‐β method, is constructed for flapping flight. Under the assumption of linear elastic deformation, this tool is capable of simulating attached flows over a thin wing and capturing unsteady effects of wakes. A bionic numerical wing with an aspect ratio of 6.5, chord Reynolds number of 1.9 × 105, and reduced frequency less than 0.1 is investigated in kinematic optimization. The computational aeroelasticity framework is combined with a global optimization algorithm to identify the optimal kinematics that maximize the propulsive efficiency under the minimum average lift constraint. Two types of numerical wings, rigid wing and flexible wing, are considered here to compare the influence of deformation on the aerodynamics of the flapping wing. The results show that the aeroelastic effect, which increases the flapping amplitude, yields a significant improvement in terms of propulsive efficiency. In addition, the optimization algorithm maximizes the thrust efficiency while satisfying the required lift. Moreover, the optimal kinematics of both the rigid wing and the flexible wing reach the maximum flapping angle, which indicates that a larger range of motions is needed for optimal kinetics when loosening the boundary conditions.
2 August 2022 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
The flow separation over a very flexible or morphing aircraft, especially during flying or oscillation at a high angle of attack, is stronger than that for conventional aircraft. However, a low-order model for reliably predicting the dynamics of the LEV and its influence on the force is still not found. It is valuable to develop such aerodynamic approaches for optimizing the wing structure and kinematics and for designing a flight control strategy considering the flow separation problem. This paper presents a two-dimensional vortex method in which an artificial boundary is constructed for the velocity adjustment of the vortices near the control panels. This artificial boundary is established in accordance with the thickness of the actual wing. A sub-time step is introduced into the solution process of the vortex method to predict the vortex locations and perform velocity adjustments. Crossing vortices retain only their tangential velocity components relative to the artificial boundary in order to avoid entering the range of the airfoil represented by the artificial boundary. Moreover, the excessive induced velocities on the control panels caused by crossing vortices are decreased, and the nonphysical behaviors and discontinuous pressure are avoided. To demonstrate the advantages of the proposed artificial boundary method in modeling an airfoil during high-angle-of-attack flight, the proposed approach is applied to a flat-plate starting problem and a flapping problem. The simulation results are then compared with the results of several experiments and numerical data for both attached and separated test cases, verifying the capabilities of the proposed method.