This paper presents a 14DOF full vehicle model which consists of ride, handling and tire subsystems to study vehicle dynamics behavior. The full vehicle model is then verified with well-known vehicle dynamics software namely CarSimEd based on the driver input from the steering wheel. Three types of vehicle dynamics test are performed for the purpose of model verification namely step steer test, double lane change test and slalom test. The results of model verification show that the behaviors of the model closely follow the behaviors obtained from CarSimEd software with acceptable error.
This paper presents an investigation into the performance of a fixed caliper based electronic wedge brake (FIXEWB) in a vehicle braking system. Two techniques were used as assessment methods, which are simulation via MATLAB Simulink software and experimental study through hardware-in-the-loop-simulation (HILS). In the simulation study, the vehicle braking system was simulated by using a validated quarter vehicle traction model with a validated FIXEWB model as the brake actuator. A proportional–integral–derivative controller was utilized as the brake torque control, whereas proportional–integral and proportional controllers were used as the position and speed control of the actuator, respectively. To study the effectiveness of the FIXEWB, the response of the vehicle using the FIXEWB is compared with the responses of a vehicle using a conventional hydraulic brake. A dynamic test, namely braking in the sudden braking at constant speeds of 40 and 60 km/h was then used as the testing method. The simulation results show that the usage of the FIXEWB with an appropriate control strategy produces similar behavior to that of a hydraulic brake in terms of the produced desired braking torque but with faster time response. To study the performance of the FIXEWB when implemented on a real vehicle, an experimental rig using HILS was designed and the results are analyzed using the same dynamic tests. The performance areas evaluated are vehicle body speed, wheel speed, tire longitudinal slip, and the stopping distance experienced by the vehicle. The outcomes from this study can be considered in the design optimization of an antilock braking system control in a real car in the future.
30 June 2013 in International Journal of Automotive and Mechanical Engineering
This paper presents a derivation of a full vehicle model to study vehicle dynamics behaviour in longitudinal direction. The full vehicle model is then validated using an instrumented experimental vehicle based on the driver input from brake and throttle pedals. Two tests are performed for the purpose of model validation, namely, sudden braking and sudden acceleration test. The results of the validation show that the behaviours of the model closely follow the behaviour of a real vehicle. An active suspension control system is then developed on the validated full vehicle model to reduce unwanted vehicle motions during braking and throttling manoeuvres. The proposed controller structure for the active suspension system is gain scheduling PID control with pitch moment rejection loop. The results show that the proposed control structure is able to significantly improve the dynamic performance of the vehicle during sudden braking and sudden acceleration under various conditions.
1 January 2010 in International Journal of Vehicle Systems Modelling and Testing
This paper provides a detailed derivation of a full vehicle model, which may be used to simulate the behaviour of a vehicle in longitudinal direction. The 14 degrees of freedom (14-DOF) vehicle model is integrated with an analytical tyre dynamics using Calspan tyre model. The full vehicle model was validated experimentally with an instrumented experimental vehicle based on the driver input from brake or throttle pedals. Several transient handling tests were performed, namely sudden acceleration and sudden braking test. Comparisons of the experimental result and model response with sudden braking and throttling imposed motion are made. The results of model validation show that the trends between simulation results and experimental data are almost similar with acceptable error. An adaptive PID control strategy was implemented on the validated full vehicle model to reduce unwanted vehicle motions in longitudinal direction during sudden braking and throttling manoeuvre. The results show that the proposed control structure is able to significantly improve the dynamic performance of the vehicle during sudden braking and sudden acceleration under various conditions.