Dexterity in robotic hands is not enough to cover the demands for more flexibility in the manufacturing process. Specifically, processes that involve cooperation or learning from humans, slippage detection and tactile feedback to improve grasp stability when different objects are manipulated, object exploration and classification, quality inspection, welding, etc. The sense of touch is the key to the capabilities of human hands, so tactile sensors must be incorporated into robotic hands to improve them. However, tactile sensing technology is not yet mature enough to be an effective tool. One reason for this limited performance is the need of acquisition and processing of large amounts of data in the short time required to perform a fluent manipulation. Smart tactile sensors can help in this goal if they are able to carry out local acquisition and processing of tactile data and transmit only relevant information through buses that guarantee bounded latency. Field-programmable gate arrays (FPGAs) are devices which are especially suitable for this task due to their ability for parallel processing. This paper presents the realization of electronics for a tactile sensor suite based on FPGAs that implements a direct interface with the raw sensor and serial communication between the fingertips and palm.
Carbon dioxide detection is a relevant issue in many fields, and this work focuses on the use of a BaTiO3-CuO sputtered thin film layer in a gas sensor prototype for air quality measurements. For this, a double side sensor was fabricated, with a Pt heater on one side and the sensing layer over the electrodes on the other side. The uniformity of the temperature on the sensing layer was tested and further tests to check its sensing performance were carried out. Humidity influence in the detection was found to be almost negligible within the usual range in air quality measurements and repeatability tests show satisfactory results for air quality control purposes.
1 November 2012 in Sensors and Actuators B: Chemical
This paper describes the fully integration of an innovative and low-cost pressure sensor sheet based on a bendable and printed electronics technology. All integration stages are covered, from most low-level functional system, like physical analog sensor data acquisition, followed by embedded data processing, to end user interactive visual application. Data acquisition embedded software and hardware was developed using a Rapid Control Prototyping (RCP). Finally, after first electronic prototype successful testing, a Taylor-made electronics was developed, reducing electronics volume to 3.5 cm × 6 cm × 2 cm with a maximum power consumption of 765 mW for both electronics and pressure sensor sheet.