Peng Dong

Peng Dong

Auto-generated profile, based on publicly available information

Peng Dong

Institute of Geosafety School of Engineering and Technology China University of Geosciences Beijing China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 April 2023 in Nature Communications
Verified
Journal Article
Open access
PDF file
PDPeng Dong
Peng Dong
KXKaiwen Xia
Kaiwen Xia
YXYing Xu
Ying Xu
DEDerek Elsworth
Derek Elsworth
JAJean-Paul Ampuero
Jean-Paul Ampuero
Earthquakes are destructive natural hazards with damage capacity dictated by rupture speeds. Traditional dynamic rupture models predict that earthquake ruptures gradually accelerate to the Rayleigh wave speed with some of them further jumping to stable supershear speeds above the Eshelby speed (~ $$\sqrt{2}$$2 times S wave speed). However, the 2018Mw7.5 Palu earthquake, among several others, significantly challenges such a viewpoint. Here we generate spontaneous shear ruptures on laboratory faults to confirm that ruptures can indeed attain steady subRayleigh or supershear propagation speeds immediately following nucleation. A self-similar analysis of dynamic rupture confirms our observation, leading to a simple model where the rupture speed is uniquely dependent on a driving load. Our results reproduce and explain a number of enigmatic field observations on earthquake speeds, including the existence of stable subEshelby supershear ruptures, early onset of supershear ruptures, and the correlation between the rupture speed and the driving load.

1 September 2020 in International Journal of Geomechanics
Verified
Journal Article
Closed access
PDF file
PDPeng Dong
Peng Dong
Bangbiao WuBangbiao Wu
Bangbiao Wu
KXKaiwen Xia
Kaiwen Xia
QWQizhi Wang
Qizhi Wang
Knowledge of fracture process is critical for understanding rock failure mechanisms. In this study, the fracture behavior of single-flawed rock-like material plates made of mortar was investigated using a Split Hopkinson Pressure Bar (SHPB) system. The transient fracture process was recorded by an ultra-high-speed camera system in combination with the digital image correlation (DIC) method. The experimental result reveals that the dynamic strength is more sensitive to the loading rate for specimens with lower flaw angles. Through quantitative analysis of the displacement evolution along the fracture trajectory, four fracture modes were proposed: pure tensile mode (T-mode), pure shear mode (S-mode), tensile dominated mode (Ts-mode), and shear-dominated mode (St-mode). Moreover, it was recognized that the fracture mode is mainly controlled by the fracture angle. As the fracture angle increases, the shear component increases while the tension component diminishes. The results of this study can shed light on the fracture behavior of flawed rocks subjected to dynamic loading.

22 February 2023 in Journal of Rock Mechanics and Geotechnical Engineering
Verified
Journal Article
Open access
KZKaiyu Zhang
Kaiyu Zhang
FLFeng Liu
Feng Liu
KXKaiwen Xia
Kaiwen Xia
YXYing Xu
Ying Xu
PDPeng Dong
Peng Dong
CYChangyi Yu
Changyi Yu

18 November 2022 in Seismological Research Letters
Verified
Journal Article
Closed access
PDF file
PDPeng Dong
Peng Dong
RCRong Chen
Rong Chen
KXKaiwen Xia
Kaiwen Xia
WYWei Yao
Wei Yao
ZPZhigang Peng
Zhigang Peng
Dereck ElsworthDereck Elsworth
Dereck Elsworth
Dynamic triggering of earthquakes by seismic waves generated by another earthquake is widely observed, while the underlying nucleation mechanisms remain unclear. We report here dynamically triggered earthquakes on laboratory faults with tightly constrained imaging of the triggering process. The arriving stress wave alters the contact state of the laboratory fault and initiates rupture nucleation in two distinct phases. The triggered rupture grows at a fraction of the shear‐wave velocity (⁠ ∼0.4CS⁠) and then transits to a very slow velocity (⁠ ∼0.1CS⁠) before culminating into runaway shear. This intervening very slow rupture phase is present only for seismic ratios conducive to sub‐Rayleigh ruptures and is notably absent for supershear events. Thus, the delay in triggering decreases to a minimum for triggered supershear ruptures, whereas it scales with the stress state for triggered sub‐Rayleigh ruptures. These results may help explain key characteristics of delayed near‐field dynamic triggering and provide a simple theoretical framework for dynamic triggering at greater distances.

7 December 2022 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Closed access
PDPeng Dong
Peng Dong
RXRan Xu
Ran Xu
HYHongfeng Yang
Hongfeng Yang
ZGZhiyin Guo
Zhiyin Guo
KXKaiwen Xia
Kaiwen Xia

26 February 2024 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Closed access
PDPeng Dong
Peng Dong
YXYing Xu
Ying Xu
RXRan Xu
Ran Xu
KXKaiwen Xia
Kaiwen Xia
JPJianbing Peng
Jianbing Peng