1 November 2007 in Kinetics and Catalysis
Zeolite H-TsVM has been loaded with palladium by different methods. The properties of the resulting catalysts in gasoline synthesis from syngas via dimethyl ether depend on the way in which palladium was introduced. The catalysts have been characterized by ammonia temperature-programmed desorption (TPD), temperature-programmed reaction with hydrogen, and X-ray photoelectron spectroscopy. According to ammonia TPD data, use of a palladium ammine complex instead of palladium chloride reduces the concentration of strong acid sites and raises the concentration of medium-strength acid sites, thereby reducing the yield of C1–C4 hydrocarbons and increasing the yield of gasoline hydrocarbons. At T = 340°C, P = 100 atm, and GHSV = 2000 h−1, the dimethyl ether conversion is 98–99%, the gasoline selectivity is >60%, the isoparaffin content of the product is ∼61%, and the arene content is not higher than 29%.
16 April 2021 in Petroleum Chemistry
Oxidative conversion of methane to acetic acid at 150°С and a pressure of 6.5 MPa with the assistance of carbon monoxide on rhodium-modified ZSM-5 zeolites with different SiO2/Al2O3 molar ratios was studied. A decrease in SiO2/Al2O3 from 300 to 30 leads to a 2.7-fold increase in the acetic acid yield. Such behavior of the catalytic system correlates with an increase in the acidity, primarily with an increase in the density of Brønsted acid sites on the zeolite surface. Introduction of 0.1–0.5 wt % rhodium into the zeolite increases the acetic acid yield by a factor of more than 3. The highest acetic acid yield (0.53 mmol/gcat) is attained on the zeolite with SiO2/Al2O3 = 33 modified with 0.5 wt % Rh. The methane transformation to acetic acid occurs while involving both the acid sites of the zeolite and the sites formed by reactive rhodium particles.
1 January 2018 in Russian Journal of Physical Chemistry A
Nanodispersed suspensions that are effective in DME conversion and stable in the reaction zone in a three-phase system (slurry reactor) are obtained from MFI zeolite commercial samples (TsVM,...
1 November 2018 in Russian Journal of Applied Chemistry
Effect of mode parameters, such as the feed gas flow rate, its content of dimethyl ether, and content of a catalyst in the suspension, on the main parameters of the dimethyl ether conversion into...
1 September 2019 in Kinetics and Catalysis
The synthesis of light C2–C4olefins from dimethyl ether (DME) in a three-phase system (slurry reactor) over nanosized MFI-type zeolites suspended in liquids with various chemical...
1 June 2023 in Petroleum Chemistry
The paper shows that introducing rhodium into zeolite significantly enhances the catalytic performance of the system. Rh/IK(UST), a catalyst sample distinguished by an increased concentration of strong acid sites, exhibited the highest activity and selectivity towards acetic acid (AA). In the presence of this catalyst, the yield of AA more than doubled, and the AA/methanol ratio increased by more than an order of magnitude, compared to the other Rh-modified catalysts. A synergistic effect of strong Brønsted acid sites and Rh single-atom sites was found. Their proximity plays a key role in this mechanism.