The influence of the method used for introduction of Rh into a ZSM-5 zeolite-based catalyst and on its physicochemical and catalytic properties exhibited in dimethyl ether conversion to light olefins was evaluated. Use of chitosan as a medium for rhodium dispersing affords a 10% increase in the dimethyl ether conversion while maintaining the selectivity for light olefins at a level of 75%, which is most likely due to location of rhodium predominantly on the zeolite surface, as well as to its high dispersion. The method of rhodium introduction also affects the amount of the formed coke deactivating the catalysts. Through the use of chitosan as a medium for rhodium dispersing and of a rotary evaporator in the zeolite impregnation stage the amount of the coke on the catalyst surface was reduced. The presence of chitosan as a polymer matrix during modification of the ultrasonically treated zeolite leads to a 6% decrease in the yield of the target reaction products (ethylene and propylene), which is associated with increased coke formation.
The paper shows that introducing rhodium into zeolite significantly enhances the catalytic performance of the system. Rh/IK(UST), a catalyst sample distinguished by an increased concentration of strong acid sites, exhibited the highest activity and selectivity towards acetic acid (AA). In the presence of this catalyst, the yield of AA more than doubled, and the AA/methanol ratio increased by more than an order of magnitude, compared to the other Rh-modified catalysts. A synergistic effect of strong Brønsted acid sites and Rh single-atom sites was found. Their proximity plays a key role in this mechanism.
In the production of light olefins from dimethyl ether, a nanozeolite catalyst modified with lanthanum and zirconium exhibited lower activity and selectivity than a magnesium-loaded zeolite catalyst. This is due to a higher percentage of strong acid sites in La–Zr/HZSM-5, which promoted secondary reactions and decreased the selectivity towards light olefins. Furthermore, the difference in the catalytic properties of the samples modified with Mg and La–Zr can be explained by the different concentrations of the methanol product: the methanol content was markedly higher in the presence of La–Zr/HZSM-5 than with Mg/HZSM-5. To gain better insight into the role of methanol in the synthesis of light olefins from dimethyl ether, the relative activity of Brønsted acid sites on the catalyst surface in the conversion of methanol and dimethyl ether was comparatively assessed using in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS). It was demonstrated that at high temperatures (above 260°C) the conversion of both DME and methanol occurs by the oxonium–ylide mechanism. However, there are differences in the formation routes of primary intermediates: formaldehyde from methanol, and ketene from dimethyl ether.
1 January 2025 in Нефтехимия / Petroleum Chemistry
В данной работе исследован одностадийный синтез низших олефинов из СО и Н при = 320°C и = 0,1 МПа на комбинированном катализаторе, состоящем из оксидного (MegaMax-507/AlO, ZnAlO, ZnO—ZrO) и цеолитного (Mg/HZSM-5) компонентов. Найдено, что оптимальное соотношение оксидного и цеолитного компонентов составляет 2 : 1. Активность упомянутых компонентов возрастает в ряду: MegaMax-507/AlO lt; ZnAlO lt; ZnO—ZrO. Использование бинарного оксида ZnO—ZrO в составе комбинированного катализатора позволяет достигать конверсии СО, равной 13,7%, при атмосферном давлении и умеренной температуре в отличие от условий, применяемых для исследований в данной области ( = 400—500°C, = 1—3 МПа).
Изучено влияние сопутствующего газа (азота, синтез-газа) на каталитические свойства цеолитных катализаторов, модифицированных Mg, La и Zr, в конверсии диметилового эфира в низшие олефины (Т = 320 ° С, Р = 0.1 МПа). Обнаружено, что синтез-газ не оказывает существенного влияния на превращение диметилового эфира в низшие олефины, и наиболее стабильным к замене реакционной среды является катализатор Mg-HZSM-5. Исследован одностадийный синтез низших олефинов из СО и Н2 при атмосферном давлении. Показано, что более эффективным является катализатор La-Zr/HZSM-5 (конверсия СО 8.6%, суммарная селективность по углеводородам С2+ 62.4 мас%), при этом в присутствии диметилового эфира не наблюдается ожидаемого прироста углеводородов С2+ за счет вовлечения СО. Это может быть связано с конкурентной адсорбцией молекул диметилового эфира и СО на активных центрах лантан-циркониевого катализатора.