Lorena Villar

Lorena Villar

Auto-generated profile, based on publicly available information

Lorena Villar

FEQX lab, Department of Chemical Engineering, University of Vigo, Vigo, Spain

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2018 in Analytica Chimica Acta
Verified
Journal Article
Closed access
Francisco Javier Pena-PereiraFrancisco Javier Pena-Pereira
Francisco Javier Pena-Pereira
LVLorena Villar-Blanco
Lorena Villar-Blanco
ILIsela Lavilla
Isela Lavilla
CBCarlos Bendicho
Carlos Bendicho

1 February 2022 in Environmental Technology & Innovation
Verified
Journal Article
Open access
OSOlalla G. Sas
Olalla G. Sas
LVLorena Villar
Lorena Villar
ÁDÁngeles Domínguez
Ángeles Domínguez
BGBegoña González
Begoña González
EMEugénia A. Macedo
Eugénia A. Macedo

22 February 2024 in Biomacromolecules
Verified
Journal Article
Open access
LVLorena Villar
Lorena Villar
ISInge Schlapp-Hackl
Inge Schlapp-Hackl
PSPablo B. Sánchez
Pablo B. Sánchez
MHMichael Hummel
Michael Hummel
Even small amounts of elastane in cotton-elastane blended textiles can prevent fiber-to-fiber recycling strategies in textile recycling. Herein, the selective separation of elastane from cotton blends was addressed by the aminolytic degradation of the synthetic component. Polar aprotic solvents were tested as elastane solvents, but side reactions impeded aminolysis with some of them. Aminolysis of elastane succeeded under mild conditions using dimethyl sulfoxide in combination with diethylenetriamine and 1,5-diazabicyclo[4.3.0]non-5-ene as a cleaving agent and catalyst, respectively. The analysis of the nitrogen content in the recovered cellulose fraction demonstrated that 2 h of reaction at 80 °C reduced the elastane content to values lower than 0.08%. The characterization of the recovered cellulose showed that the applied conditions did not affect the macromolecular properties of cellulose and maintained a cellulose I crystal structure. Degraded elastane products were recovered through precipitation with water. Finally, the cellulosic component was turned into new fibers by dry-jet wet spinning with excellent tensile properties.

30 January 2023 in Cellulose
Verified
Journal Article
Open access
PDF file
LVLorena Villar
Lorena Villar
MPMarta Pita-Fernández
Marta Pita-Fernández
JPJavier Paez
Javier Paez
PSPablo B. Sánchez
Pablo B. Sánchez
Aiming to increase the scarce information available on the kinetics of cellulose dissolution, we have applied an image-assisted technique based on the luminance evolution as cellulose dissolves to study this process under different experimental conditions. This protocol was validated via direct determination of the cellulose dissolved. In all cases datapoints were linearly fitted assuming a pseudo-zero order reaction which facilitates the comparison between datasets. To study the solvent effect we have used three ionic liquids with large basicity and found significantly different rates of dissolution, from faster to slower: [C $$_2$$ 2 C $$_1$$ 1 Im][OAc]>[C $$_1$$ 1 C $$_1$$ 1 Im][DMP]>[C $$_2$$ 2 C $$_1$$ 1 Im][DEP]. Solvatochromic parameters and viscosity of the solvent media were determined and the latter was identified as a key factor slowing the process as it reduces ionic mobility. The weight of viscosity was estimated by removing the viscosity effect with a tuned solvent media doped with DMSO. Activation energy was 70% lower at constant viscosity. On the substrate side, particle size is the main factor affecting the dissolution rate. All samples were milled to homogenise the starting material and minimise the distortions caused by the size distribution. After, dissolution of three cellulose substrates under the same experimental conditions was analysed. Dissolution of natural fibers took twice as long as dissolving pulp which dissolves slower than lyocell fibers. This trend correlates with the roughness of the samples obtained by optical perfilometry which is consistent with the dissolution mechanism proposed in the literature. Graphical abstract

15 December 2022 in Separations
Verified
Journal Article
Open access
PDF file
LVLorena Villar
Lorena Villar
ÓRÓscar Martínez Rico
Óscar Martínez Rico
AAAndrés Asla
Andrés Asla
ÁDÁngeles Domínguez
Ángeles Domínguez
BGBegoña González
Begoña González
Textile industries release dangerous wastewater that contain dyes into the environment. Due to their toxic, carcinogenic and mutagenic nature, they must be removed before the discharge. Liquid–liquid extraction has proven to be an efficient method for the removal of these dyes. As extractants, deep eutectic solvents (DESs) have shown excellent results in recent years, as well as presenting several green properties. Therefore, four different hydrophobic DESs based on natural components were prepared thymol:decanoic acid (T:D (1:1)), thymol:DL-menthol (T:M (1:1)), thymol:DL-menthol (T:M (1:2)) and thymol:coumarin (T:C (2:1)) for the extraction of Malachite Green (MG), Brilliant Blue G (BBG), Acid Yellow 73 (AY73), Reactive Red 29 (RR29), Acid Blue 113 (AB113), Reactive Black 5 (RB5), Remazol Brilliant Blue (RBB), Direct Yellow 27 (DY27), Acid Blue 80 (AB80), Direct Blue 15 (DB15) and Acid Violet 43 (AV43) dyes from water. The operational parameters of the liquid–liquid extraction were selected in order to save time and materials, resulting in 30 min of stirring, 15 min of centrifugation and an aqueous:organic ratio of 5:1. In these conditions, the highest values of extraction obtained were 99% for MG, 89% for BBG and 94% for AY73. Based on these results, the influence of the aqueous:organic phase ratio and the number of necessary stages to achieve water decolorization was studied.

24 June 2024 in Fibers and Polymers
Verified
Journal Article
Open access
PDF file
LVLorena Villar
Lorena Villar
MPMarta Pita-Fernández
Marta Pita-Fernández
BGBegoña González
Begoña González
PSPablo B. Sánchez
Pablo B. Sánchez
Resulting properties of cotton and polyester blends make polycotton the most common fabric in textile industry. Separation technologies are key for the chemical processing of the massive amount of polycotton waste produced worldwide. The very different chemical nature of cellulose and polyethylene terephthalate determines the fractionation strategies to obtain two valuable monomaterial streams. In this work, we propose separation pathways seeking the conversion both polymers. First, polyester was depolymerised into its monomeric units through catalytic alkaline hydrolysis. The combined effect of alkali concentration and the catalyst was analysed to overcome the hydrophobic nature of polyester and optimise its conversion rate minimising the damaged caused to the cellulose chains. Conversion rates up to 80% were reached in a single separation stage with a limited effect of the polymer chain distribution of cellulose which remains a fiber-grade feedstock. Alternatively, cellulose was fully removed by selective dissolution in ionic solvent and subsequent filtration resulting in a spinnable mixture. Finally, enzymatic treatments for the conversion of cellulose into fermentable sugars were studied. Single stage conversions of 65% were achieved after maximizing the enzymatic activity. Structural and spectroscopic analysis showed that crystalline domains of textile-grade cotton limit the enzymatic activity. Optimal fractionation process is, in our view, highly context dependent what conveys to seek a variety of alternatives seeking for chemical processes driven by the ulterior up-cycling of the monomaterial streams