Sergey N. Vainshtein

Sergey N. Vainshtein

Auto-generated profile, based on publicly available information

Sergey N. Vainshtein

Department of Electronics and Nanoengineering, MilliLab, Aalto University, Aalto, Finland

Research Focus & Metrics

Academic Career Length

27Years (2000-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 February 2008 in Applied Physics Letters
Verified
Journal Article
Closed access
SVSergey Vainshtein
Sergey Vainshtein
VYValentin Yuferev
Valentin Yuferev
VPVassil Palankovski
Vassil Palankovski
DODuu-Sheng Ong
Duu-Sheng Ong
JKJuha Kostamovaara
Juha Kostamovaara
Direct measurement of the electron velocity vn at an extreme electric field E is problematic due to impact ionization. The dependence vn(E) obtained by a Monte Carlo method can be verified, however, by comparing simulated and experimental data on superfast switching in a GaAs bipolar transistor structure, in which the switching transient is very sensitive to this dependence at high electric fields (up to 0.6MV∕cm). Such a comparison allows the conclusion to be made that the change from negative to positive differential mobility predicted earlier at E∼0.3MV∕cm should not happen until the electric field exceeds 0.6MV∕cm.

24 June 2016 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
SVSergey N. Vainshtein
Sergey N. Vainshtein
GDGuoyong Duan
Guoyong Duan
AFAlexey Filimonov
Alexey Filimonov
JKJuha Kostamovaara
Juha Kostamovaara
Although Marx-bank connection of avalanche transistors is widely used in applications requiring high-voltage nanosecond and subnanosecond pulses, the physical mechanisms responsible for the voltage-ramp-initiated switching of a single transistor in the Marx chain remain unclear. It is shown here by detailed comparison of experiments with physical modeling that picosecond switching determined by double avalanche injection in the collector-base diode gives way to formation and shrinkage of the collector field domain typical of avalanche transistors under the second breakdown. The latter regime, characterized by a lower residual voltage, becomes possible despite a short-connected emitter and base, thanks to the 2-D effects.

10 July 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
SVSergey N. Vainshtein
Sergey N. Vainshtein
VZValery Zemlyakov
Valery Zemlyakov
VEVladimir Egorkin
Vladimir Egorkin
AMAndrey Maslevtsov
Andrey Maslevtsov
AFAlexey Filimonov
Alexey Filimonov
The-state-of-the-art in long-distance near-infrared optical radars is the use of laser-diode-based miniature pulsed transmitters producing optical pulses of 3-10 ns in duration and peak power typically below 40W. The duration of the transmitted optical pulses becomes a bottleneck in the task of improving the radar ranging precision, particularly due to the progress made in developing single photon avalanche detectors (SPADs). The speed of miniature high-current drivers is limited by the speed of the semiconductor switch, either a gallium nitride (GaN) field-effect transistor, the most popular alternative nowadays, or a silicon avalanche bipolar junction transistor (ABJT), which was traditional in the past. Recent progress in the physical understanding of peculiar 3-D transients promises further enhancement in speed and efficiency of properly modified ABJTs, but that is not the only factor limiting the transmitter speed. We show here that a low-inductance miniature transmitter assembly containing only a specially developed capacitor, a more advanced transistor chip than that used in commercial ABJTs and a laser diode has allowed peak power from 40 to 180 W to be reached in optical pulses of 1-2 ns in duration without after-pulsing relaxation oscillations. This finding is of interest for compact low-cost, long-distance decimetre-precision lidars, particularly for automotive applications.

17 February 2010 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
SVSergey N. Vainshtein
Sergey N. Vainshtein
VYValentin S. Yuferev
Valentin S. Yuferev
JKJuha Kostamovaara
Juha Kostamovaara
MKMarina M. Kulagina
Marina M. Kulagina
HMHannu T. Moilanen
Hannu T. Moilanen
A drastic reduction in the residual voltage (from ~ 100 V to a few volts) and a significant (factor of ~ 2) increase in the dU/dt switching rate is demonstrated experimentally in the superfast ( ~ 200 ps) avalanche switching of a GaAs bipolar junction transistor with increased emitter area. This result is not a trivial one as only a small number of conductive channels of a few micrometers in diameter participate in the transient independently of the emitter size, while the remaining (passive) part of the structure supplies the switching channels with the currents circulating inside the chip, which makes the impact ionization in the filaments even more powerful. Excellent agreement was found between the experiment and a ¿two-transistor¿ model specially developed here, with one transistor simulating the switching channels and the other the nonswitched part of the structure. Much higher switching stability and reproducibility and much lower power dissipation were observed in the structure with increased emitter area.

16 September 2019 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
SVSergey N. Vainshtein
Sergey N. Vainshtein
GDGuoyong Duan
Guoyong Duan
VYValentin S. Yuferev
Valentin S. Yuferev
VZValery E. Zemlyakov
Valery E. Zemlyakov
VEVladimir I. Egorkin
Vladimir I. Egorkin
JKJuha T. Kostamovaara
Juha T. Kostamovaara
A simple miniature source generating pulse trains with a central frequency of ∼100 GHz and a duration of 50–100 ps has been demonstrated recently. The source is based on nanometer-scale collapsing field domains (CFDs) generated in the collector of an avalanching bipolar GaAs transistor. The central frequency is determined by the domain transient time across the collector, and thus, a routine increase in the oscillation frequency from 0.1 to 0.3–0.5 THz would require a reduction in the collector thickness by a factor of 3–5. This is not acceptable, however, since it would reduce the maximum blocking voltage affecting the achievable peak current across the avalanche switch. We suggest here a solution to this challenging problem by reducing the CFD travel distance while keeping the collector thickness unchanged. Here, the discovered and interpreted phenomenon of CFD collapse when entering a dense carrier plasma zone made it possible by means of bandgap engineering. A CFD emitter generating ∼200 GHz wavetrains of ∼100 ps in duration is demonstrated. This finding opens an avenue for the increase in the oscillation frequency without any reduction in the emitted power, by using a smart structure design.

8 December 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
IPIlya A. Prudaev
Ilya A. Prudaev
SVSergey N. Vainshtein
Sergey N. Vainshtein
MVMaksim G. Verkholetov
Maksim G. Verkholetov
VOVladimir L. Oleinik
Vladimir L. Oleinik
VKViktor Kopyev
Viktor Kopyev
The article is concerned with a detailed switching delay effect exhibited by avalanche S-diodes--superfast GaAs closing switches doped with deep Fe centers. The current and voltage time dependences are simulated in a simplified generator. The dynamic electric field and charge profiles in the structures are calculated. This article describes an impact that Fe capture cross sections of free charge carriers have on delayed switching. The simulation results show that delayed switching is associated with deep center recharging in a double injection mode due to three different processes. There are two different delay mechanisms to be herewith distinguished. A delay effect is experimentally viewed to control the dynamic switching voltage (and the avalanche breakdown voltage) using constant voltage adjustment capability enabled by a triggering circuit supply. The authors demonstrate the way it is possible to adjust the amplitude of current nanosecond pulses in the range of 20-45 A through a lidar transmitter circuit with a semiconductor laser and nonoptimized S-diode. The findings are consistent with the results of numerical simulation.