1 April 2016 in Solar Energy Materials and Solar Cells
1 September 2021 in Solar Energy Materials and Solar Cells
9 August 2012 in IEEE Journal of Photovoltaics
The poor charge-carrier transport properties attributed to nanostructured surfaces have been so far more detrimental for final device operation than the gain obtained from the reduced reflectance. Here, we demonstrate results that simultaneously show a huge improvement in the light absorption and in the surface passivation by applying atomic layer coating on highly absorbing silicon nanostructures. The results advance the development of photovoltaic applications, including high-efficiency solar cells or any devices, that require high-sensitivity light response.
28 May 2013 in Journal of Applied Physics
Nickel is increasingly used in both IC and photovoltaic device fabrication, yet it has the potential to create highly recombination-active precipitates in silicon. For nearly three decades, the accepted nickel diffusivity in silicon has been DNi(T)=2.3×10−3exp(−0.47 eV/kBT) cm2/s, a surprisingly low value given reports of rapid nickel diffusion in industrial applications. In this paper, we employ modern experimental methods to measure the higher nickel diffusivity DNi(T)=(1.69±0.74)×10−4exp(−0.15±0.04 eV/kBT) cm2/s. The measured activation energy is close to that predicted by first-principles theory using the nudged-elastic-band method. Our measured diffusivity of nickel is higher than previously published values at temperatures below 1150 °C, and orders of magnitude higher when extrapolated to room temperature.
8 September 2020 in Physical Review Letters
At present, ultraviolet sensors are utilized in numerous fields ranging from various spectroscopy applications via biotechnical innovations to industrial process control. Despite this, the performance of current UV sensors is surprisingly poor. Here, we break the theoretical one-photon–one-electron barrier and demonstrate a device with a certified external quantum efficiency above 130% in UV range without external amplification. The record high performance is obtained using a nanostructured silicon photodiode with self-induced junction. We show that the high efficiency is based on effective utilization of multiple carrier generation by impact ionization taking place in the nanostructures. While the results can readily have a significant impact on the UV-sensor industry, the underlying technological concept can be applied to other semiconductor materials, thereby extending above unity response to longer wavelengths and offering new perspectives for improving efficiencies beyond the Shockley-Queisser limit.
1 November 2015 in Solar Energy Materials and Solar Cells
NOTICE: this is the author’s version of a work that was accepted for publication in Solar Energy Materials and Solar Cells. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Solar Energy Materials and Solar Cells, vol. 142, (November 2015) doi:10.1016/j.solmat.2015.05.027We demonstrate that n-type black silicon can be passivated efficiently using Atomic Layer Deposited (ALD) Al2O3, reaching maximum surface recombination velocities below 7 cm/s. We show that the low surface recombination velocity results from a higher sensitivity of the nanostructures to surface charge and from the absence of surface damage after black silicon etching. The surface recombination velocity is shown to be inversely proportional to the fourth power of the negative charge in contrast to the quadratic dependence observed in planar surfaces. This effect compensates the impact of the increased surface area in the nanostructures and extends the potential of black silicon for instance to n-type Interdigitated Back Contact (IBC) cells.Peer ReviewedPostprint (author's final draft