4 July 2013 in Soft Matter
Electrically induced patterning is a process for fabricating micro- or nano-structures where a voltage is applied between a conductive template and a polymer-coated substrate, sandwiching an air gap. In the structure-forming process, the polymer film is pulled upwards non-uniformly to the template under the influence of an electric field spatially modulated by protrusions and cavities of the template pattern, being deformed into a structure positive to the template pattern. This paper explores applicability of the electrically induced patterning process in duplicating an irregular structure with features of significantly varying size from a template onto the polymer, and shows that irregular structures, such as the one composed of features with a linewidth varying from 2 μm to 20 μm, as in our experiment and numerical simulation, can be formed on the polymer by a spatially fine-modulated electric field. A ratio of modified most unstable wavelength on the characteristic length and a mass parameter are proposed in terms of the major process variables to define the regimes of spatial modulation by the electric field, i.e. under-modulation, fine-modulation and over-modulation. In addition, an experiment is also performed to duplicate clusters of cylindrical pillars and square prisms sized from 5 μm to 40 μm by tuning the process into a regime of fine-modulation. The experimental results have shown an applicability of the ratio of the modified most unstable wavelength on the characteristic length and the mass parameter in characterizing this structuring method.
1 September 2014 in Synthetic Metals
1 January 2010 in Journal of Vacuum Science & Technology B
The preparation of microstructures with certain patterns on a large-area substrate, especially on a flexible substrate, is a critical step in the development or production of flexible electronics (or macroelectronics). In this article, a novel roller-reversal imprint (RRI) process for the generation of large-area microstructures is proposed. In contrast to other published roller-imprint processes (such as hot embossing and ultraviolet roller-imprint), in which the material to be patterned is firstly film coated on the substrate and then the mold roller is pressed to the film, the RRI process starts with coating of the ink (mostly various liquefied electronics materials, such as a semiconductor polymer) on a patterned mold roller and then transferring the patterned ink to the substrate. The RRI process can be used to prepare micropatterns of various ink materials on a flexible substrate. By properly controlling the ink filling the microcavities on the mold roller and ink transfer to the substrate, the RRI process can achieve a pattern transfer without forming an undesirable residual layer, which is typical in other imprint processes. Furthermore, an experimental device for the RRI process is also developed for ink transfer to a flat, flexible substrate. A four-step alignment approach for the preparation of multilayer microstructures (as required in active macroelectronics) is proposed for the RRI, achieving an alignment accuracy of 0.2μm and an overlay error of about 5μm.
3 February 2016 in Journal of Materials Science: Materials in Electronics
1 June 2009 in Applied Surface Science
24 February 2014 in The Scientific World Journal
Electrohydrodynamic patterning of arbitrary patterns is achieved by optimizing the critical parameters (applied voltage and spacer height). The applied voltage has a great influence on the fidelity of L-shaped line structures with different sizes. The L-shaped line structures with high fidelity are obtained by using the moderate applied voltage. The spacer height has a great influence on the fidelity of square structures with different sizes. The square structures with high fidelity are obtained by using the low height spacer. The multi-field coupling transient finite element simulation demonstrates that the lack of polymer owing to the high height spacer leads to the formation of defects.