Liliana Inés Perez

Liliana Inés Perez

Auto-generated profile, based on publicly available information

Liliana Inés Perez

Facultad de Ingeniería, Grupo de Láser, Óptica de Materiales y Aplicaciones Electromagnéticas (GLOMAE), Universidad de Buenos Aires, Buenos Aires, Argentina

Research Focus & Metrics

Academic Career Length

29Years (1998-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 1998 in Journal of Modern Optics
Verified
Journal Article
Closed access
LPLiliana I. Perez
Liliana I. Perez
FCFernando Ciocci
Fernando Ciocci
First-order nonspecular effects for Gaussian beams reflected on the first interface of a system formed by two interfaces of isotropic materials are studied. The complex lateral displacement is analytically determined and the validity of the approximations made is analysed. It is shown that the lateral displacement is independent of the beam waist and the approximation results suitable even for very narrow beams near Brewster's condition. With a dielectric-metal-dielectric configuration (Kretschmann's) and under resonance conditions, lateral displacements of up to 25% of the beam width can be obtained.

16 June 2021 in Journal of Modern Optics
Verified
Journal Article
Closed access
RARicardo David Araguillin
Ricardo David Araguillin
LBLigia Ciocci Brazzano
Ligia Ciocci Brazzano
LPLiliana Inés Perez
Liliana Inés Perez
FVFrancisco E. Veiras
Francisco E. Veiras
Sensors based on surface plasmon resonance present attractive features for the detection of narrow acoustic pulses since they can behave as quasi-point detectors. In order to detect fast ultrasound pressure waves, the system senses the intensity of the reflected beam for a fixed angle of incidence and for a fixed wavelength. Therefore, optimal conditions for Kretschmann's glass-metal-water configuration are presented. Optimization is performed by means of numerical simulations of the reflectivity curves for different low-cost metallic films with different thicknesses and angles of incidence. Zn, Ti, Cr, Al, and Cu are evaluated and compared with Au. In addition, the wavelength selection is discussed, and the oxidation effects are also briefly analysed.

1 April 2016 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
FVF. E. Veiras
F. E. Veiras
MGM. T. Garea
M. T. Garea
LPL. I. Perez
L. I. Perez
Conoscopic interferometry for crystal characterization is a very well-known technique with increasing applications in different fields of technology. The advantage of the scheme proposed here is the introduction of a polarization modulator that allows the recovery of the phase information contained in conoscopic interferograms. This represents a real advantage since the most relevant physical information of the sample under study is usually contained in the phase of the fringe pattern. Moreover, this technique works successfully even when there are no visible fringes. The setup employed is a simple conoscopic interferometer where the elements under study correspond to two birefringent crystal slabs and a commercial mica wave plate. It allows the crystals to be characterized and the wave plate retardance to be measured as a function of the angle of incidence. The modulator itself consists of a single tiltable crystal plate which, by means of phase shifting techniques, permits the recovery of a phase map for each sample. It is inexpensive and it can be easily calibrated, so it works with a wide range of phase shifting interferometry algorithms. We show that our scheme is easily adaptable to algorithms that require either a low or high amount of interferograms.

14 November 2023 in Optik
Verified
Journal Article
Closed access
GCGerman E. Caro
German E. Caro
EAEduardo O. Acosta
Eduardo O. Acosta
FVFrancisco E. Veiras
Francisco E. Veiras
LPLiliana I. Perez
Liliana I. Perez

1 January 2008
Verified
Conference Paper
Closed access
PDF file
FVFrancisco E. Veiras
Francisco E. Veiras
LPLiliana I. Perez
Liliana I. Perez
An explicit expression for phase difference introduced by ideal waveplates is obtained based on Fermat’s principle. The results obtained differ from the ones in literature and turn out to be useful for their design.