29 March 2018 in IEEE Transactions on Industrial Informatics
Barely visible impact damage (BVID) is inevitable during either fabrication or lifetime of a carbon fiber reinforced plastic (CFRP) component. These flaws are usually difficult to be detected from the surface by visual inspection or machine vision based on a charge-coupled device or CMOS. In order to solve the problems of low efficiency, low sensitivity, and small detection area of the existing nondestructive testing (NDT) for BVID in CFRP, this paper proposes for the first time the integrated nonlinear ultrasound (NU) and vibrothermography (VT) NDT based on the shared excitation sources. The experimental system was built after introducing the principle of shared excitation based NU&VT NDT. The CFRP plates with 5, 15, and 25 J visible impact damage (VID) as well as 12 and 16 J BVID were tested using the integrated NU&VT. Experimental studies after signal processing have shown that all VID and BVID could be detected by the integrated NU&VT NDT, and the defection capability has a significant improvement after fast Fourier transform. The proposed method could provide a visualized and effective means for quality control and inspection of large-scaled and complex shape key components in manufacturing process and in service.
21 August 2018 in IEEE Transactions on Industrial Informatics
Impact damage, caused by low-energy impact, is inevitable during the whole life time of carbon fiber reinforced plastic (CFRP) material. However, the barely visible impact damage (BVID) is difficult to be detected by visual methods. Ultrasonic thermography (UT) is an emerging non-destructive testing technique that visualizes damage in thermal images captured by an infrared (IR) camera when the material is stimulated by ultrasound. However, noise and blurry edges around the high temperature areas may cause confusion and lead to unreliable results in the thermal images of UT test. In this work, an impact damage inspection method is proposed based on manifold learning for CFRP material. Low-power ultrasonic excitation is used for this UT. The IR image sequences are processed as data sets in high-dimensional space. These data sets are reduced to lower dimensions by manifold learning to find the intrinsic structure in the two-dimensional manifold. Each dimension of the embedding manifold correlates highly with one degree of freedom underlying the original pixel: steady and random components. The steady component, which reflects the temperature rise caused by damage, is used for VID and BVID detection. The experimental system was set up, and CFRP plate specimens with different impact damage were tested. All the impact damage could be detected and shown in reconstructed static image with little noise. The proposed method using image sequences could provide a visualized, reliable and effective impact damage inspection and localization means for CFRP material during manufacturing and in service.
12 June 2018 in IEEE Sensors Journal
In the whole life time of carbon fiber reinforced plastic (CFRP) component, it will inevitably suffer from low-energy impact (LEI) loads, which may lead to barely visible impact damage (BVID). Thus, non-destructive testing (NDT) of impact damage has attracted more and more attention. In this work, the detection of BVID in CFRP plates induced by LEI is investigated by means of nonlinear ultrasound (NU) with the help of signal sparse reconstruction with overcomplete dictionary obtained from training of the acquired responses of the undamaged component. A damage inspection and structural health monitoring (SHM) framework for CFRP component is proposed. The intact CFRP plate specimen and specimens with 12J and 16J BVID were tested using the proposed method. Experimental results have shown that all the BVIDs could be detected effectively using a short segment of response signal. The proposed method has potential application in instrumentation design for unsupervised damage inspection and SHM during daily maintain in service of CFRP material.