Centre for Industrial Service and Design, Technological University of the Shannon, Midlands Midwest, Dublin Road, N37 HD68 Athlone, Co. Westmeath, Ireland
Auto-generated profile, based on publicly available information
Gavin Keane
Centre for Industrial Service and Design, Technological University of the Shannon, Midlands Midwest, Dublin Road, N37 HD68 Athlone, Co. Westmeath, Ireland
Stimuli-responsive hydrogels are one type of smart hydrogel, which can expand/contract in water according to changes in the surrounding environment. However, it is difficult to develop flexible shapeshifting behaviours by using a single hydrogel material. This study exploited a new method to utilise single and bilayer structures to allow hydrogel-based materials to exhibit controllable shape-shifting behaviours. Although other studies have demonstrated similar transformation behaviours, this is the first report of such smart materials developed using photopolymerised N-vinyl caprolactam (NVCL)-based polymers. Our contribution provides a straightforward method in the fabrication of deformable structures. In the presence of water, the bending behaviours (vertex-to-vertex and edge-to-edge) were achieved in monolayer squares. By controlling the content and combination of the NVCL solutions with elastic resin, the bilayer strips were prepared. The expected reversible self-bending and self-helixing behaviours were achieved in specific types of samples. In addition, by limiting the expansion time of the bilayer, the layered flower samples exhibited predictable self-curving shape transformation behaviour in at least three cycles of testing. These structures displayed the capacity of self-transformation, and the value and functionality of the produced components are reflected in this paper.
The design and manufacturing of objects in various industries have been fundamentally altered by the introduction of D-dimensional (3D) and four-dimensional (4D) printing technologies. Four-dimensional printing, a relatively new technique, has emerged as a result of the ongoing development and advancements in 3D printing. In this study, a stimulus-responsive material, N-Vinylcaprolactam-co-DEGDA (NVCL-co-DEGDA) resin, was synthesised by Stereolithography (SLA) 3D printing technique. The N-Vinylcaprolactam-co-DEGDA resins were initiated by the Diphenyl (2,4,6-trimethylbenzoyl) phosphine oxide (TPO) photoinitiator. A range of Di(ethylene glycol) diacrylate (DEGDA) concentrations in the NVCL-co-DEGDA resin was explored, ranging from 5 wt% to 40 wt%. The structural properties of the 3D printed objects were investigated by conducting Attenuated Total Reflectance–Fourier Transform Infrared Spectroscopy (ATR-FTIR). Additionally, the 3D printed samples underwent further characterisation through differential scanning calorimetry (DSC) and swelling analysis. The results revealed an inverse relationship between DEGDA concentration and Tg values, indicating that higher concentrations of DEGDA resulted in lower Tg values. Additionally, the pulsatile swelling studies demonstrated that increasing DEGDA concentration prolonged the time required to reach the maximum swelling ratio. These findings highlight the influence of DEGDA concentration on both the thermal properties and swelling behaviour of 3D printed samples.