Capacitive sensing electronics are critical to space gravitational wave detection missions, providing the test mass motion information for the inertial sensor’s non-sensitive axis control and the drag-free control of the satellite. For the TianQin mission, the capacitive sensor requirement is at 6 mHz, corresponding to a displacement noise of . This paper presents the system design scheme, noise analysis, and performance testing of the capacitive sensor for the TianQin mission. Based on the previous work of our group, a capacitive sensing scheme based on a transformer bridge and modulation–demodulation is adopted. A transformer with a better high LQ product is fabricated, and the preamplifier current noise is reduced to further improve the performance above mHz. The amplitude stability of the AC carrier and the performance of the lock-in amplifier circuit are further improved to reduce the low-frequency noise at and below. Finally, a capacitive sensor prototype is developed and tested, the experimental results show that the capacitance measurement noise is better than above 1 mHz and better than at about , which meets the overall performance requirement of the TianQin mission.
1 February 2023 in Review of Scientific Instruments
The physical mechanism of the patch effect is still an open question. Thus, a high-precision surface potential mapping facility based on a specially designed electrostatically-controlled torsion pendulum is proposed in this paper. The facility not only features high sensitivity and a two-dimensional mapping function but also adapts to various measurement requirements for centimeter-sized samples. The sensitivity of the torsion pendulum reaches about 2.0 × 10−14 N m/Hz1/2 in a frequency range of 1–8 mHz. The temporal variation of the surface potential can be detected at a level of 30 μV/Hz1/2 with a probe whose surface area is 7 mm2. The potential spatial distribution resolution comes to 0.1 mm2 at a level of 40 μV with 1 h integration time.
Patch effect is important for ultra-sensitive experiments involving closely spaced conducting surfaces. A scanning probe equipped torsion pendulum is an experimental apparatus for measuring spatial resolved patch potential on conductive surfaces. An effective approach to improve its measurement precision is by the optimization on the amplitude and frequency of the injected signal in the probe. In this paper, a method based on single- and double-frequency signal injection modes is proposed. The analysis results demonstrate that the potential resolution could achieve the level of 2–4 μV/Hz1/2. In the same integration time, the surface potential precision in the double-frequency mode is twice better than that in the single-frequency mode. In addition, when achieving the same measurement precision, the double-frequency mode takes less time than the single-frequency mode, which improves the measuring efficiency.
Patch effect on conductive surfaces is one of the critical noise sources in many scientific experiments like space gravity programs and gravitational wave detection missions. A high-precision probe-torsion instrument has been developed on ground for measuring patch effect. However, the translation mode of the probe resulting from the environmental disturbance will inevitably affect the measurement in the concerned torsion degree of freedom. In this paper, combining the theoretical analysis as well as the confirmatory experiment, the method based on data analysis is adopted to eliminate the translation effect, finally realizing the best surface potential resolution level of 20 µV Hz .
5 November 2025 in IEEE Transactions on Circuits and Systems II: Express Briefs
The sine carrier is widely used to realize the modulation for the information in many fields like electrical communication and scientific measurement. Specifically in high-precision measurements, a sine carrier endowed with ultrahigh amplitude stability is of paramount importance. In this brief, based on direct digital synthesis (DDS), a sine carrier generator is introduced with a stepwise-approximated sine wave (SASW) being band-pass filtered. Through the joint optimization of multiple parameters, a novel theoretical approach is investigated for improving the fundamental amplitude stability (FAS) of the SASW. Finally, a simulation utilizing a self-multiplying evaluation system model is performed and the simulation results verify the theory well.