20 August 2020 in Classical and Quantum Gravity
TianQin is a proposed space-based gravitational wave observatory. It is designed to detect the gravitational wave signals in the frequency range of 0.1 mHz–1 Hz. At a geocentric distance of 10 5 km, the plasma in the Earth magnetosphere will contribute as the main source of environmental noises. Here, we analyze the acceleration noises that are caused by the magnetic field of space plasma for the test mass of TianQin. The real solar wind data observed by the Advanced Composition Explorer are taken as the input of the magnetohydrodynamic simulation. The Space Weather Modeling Framework is used to simulate the global magnetosphere of the Earth, from which we obtain the plasma and magnetic field parameters on the detector’s orbits at φ
s
= 0°, 30°, 60° and 90°, where φ
s
is the acute angle between the line that joins the Sun and the Earth and the projection of the normal of the detector’s plane on the ecliptic plane. We calculate the time series of the residual accelerations and the corresponding amplitude spectral densities on these orbit configurations. We find that the residual acceleration produced by the interaction between the TM’s magnetic moment induced by the space magnetic field and the spacecraft magnetic field (
a
M1 ) is the dominant term, which can approach 10 −15 m s –2 Hz –1/2 at f ≈ 0.2 mHz for the nominal values of the magnetic susceptibility ( χ m = 10 −5 ) and the magnetic shielding factor ( ξ m = 10) of the test mass. The ratios between the amplitude spectral density of the acceleration noise caused by the space magnetic field and the preliminary goal of the inertial sensor are 0.38 and 0.08 at 1 mHz and 10 mHz, respectively. We discuss the further reduction of this acceleration noise by decreasing χ m and/or increasing ξ m in the future instrumentation development for TianQin.
5 July 2022 in Classical and Quantum Gravity
Drag-free control (DFC) is one of the key technologies for space-borne gravitational wave detectors. For the TianQin (TQ) project, non-gravitational disturbances on the spacecraft must be suppressed by DFC. TianQin-1 (TQ-1) is the first satellite for technology verification, whose main goal is to verify the disturbances reduction technologies. In this paper, the DFC requirement and preliminary analysis for the TQ project are introduced, and then the design and the experimental validation with the TQ-1 satellite is presented. In-orbit results show a successful validation of DFC and the residual acceleration of TQ-1 satellite has been suppressed to at 10 mHz versus thruster noise.
1 February 2023 in Review of Scientific Instruments
The physical mechanism of the patch effect is still an open question. Thus, a high-precision surface potential mapping facility based on a specially designed electrostatically-controlled torsion pendulum is proposed in this paper. The facility not only features high sensitivity and a two-dimensional mapping function but also adapts to various measurement requirements for centimeter-sized samples. The sensitivity of the torsion pendulum reaches about 2.0 × 10−14 N m/Hz1/2 in a frequency range of 1–8 mHz. The temporal variation of the surface potential can be detected at a level of 30 μV/Hz1/2 with a probe whose surface area is 7 mm2. The potential spatial distribution resolution comes to 0.1 mm2 at a level of 40 μV with 1 h integration time.
1 June 2022 in Review of Scientific Instruments
Patch effect is important for ultra-sensitive experiments involving closely spaced conducting surfaces. A scanning probe equipped torsion pendulum is an experimental apparatus for measuring spatial resolved patch potential on conductive surfaces. An effective approach to improve its measurement precision is by the optimization on the amplitude and frequency of the injected signal in the probe. In this paper, a method based on single- and double-frequency signal injection modes is proposed. The analysis results demonstrate that the potential resolution could achieve the level of 2–4 μV/Hz1/2. In the same integration time, the surface potential precision in the double-frequency mode is twice better than that in the single-frequency mode. In addition, when achieving the same measurement precision, the double-frequency mode takes less time than the single-frequency mode, which improves the measuring efficiency.
29 August 2023 in Classical and Quantum Gravity
High-precision electrostatic accelerometer has been widely employed in gravity measurement satellites. Accelerometer can be designed for different resolutions and measurement ranges to adapt to different scientific missions. This paper presents an ultra-high sensitivity 70 g-TM electrostatic accelerometer, designed to achieve an adjustable resolution from to with an optimal resolution of . The in-orbit performance of the 70 g-TM accelerometer was tested on the Tianqin-1 satellite.