The Zn–BTC, Co–BTC and Zn–Co–BTC series metal–organic frameworks were successfully prepared by a gas–solid two-phase flow (GSF) method with zinc nitrate, cobalt nitrate, and 1,3,5-benzenetricarboxylic acid (H3BTC) as raw materials. Single-crystal structures were obtained by the solvothermal method, and the structure and thermal stability of the target materials were characterized by FT-IR, XRD, SEM, energy-dispersive X-ray spectroscopy and DTA. The three obtained target substances were applied to catalyze the thermal decomposition of ammonium perchlorate (AP), and the performance was longitudinally compared. Testing and calculation results showed that when 10 wt% of the sample was added, monometallic Zn–BTC and Co–BTC lowered the AP pyrolysis temperature by 64.1 °C and 92.3 °C, respectively, and their activation energies decreased from 215.96 kJ mol−1 to 136.27 kJ mol−1 and 125.29 kJ mol−1, respectively. Bimetallic Zn–Co–BTC lowered the AP pyrolysis peak by 103.1 °C and the activation energy to 115.56 kJ mol−1, indicating that the series of samples exhibited good catalytic performance, and the catalytic effect of the bimetallic sample was significantly better than those of the monometallic samples.
Activated carbon (AC) has been widely used in water treatment because of its rich pore structure, large specific surface area, simple production process, low preparation cost and wide source of raw materials. In this paper, the regeneration efficiency of low-frequency ultrasonic pretreatment (40 kHz, 115Μw/cm3) on biological activated carbon (BAC) is investigated, and its principle is discussed. The results show that the micro-jet and micro-liquid flow with high temperature and pressure produced by micro-bubble rupture during ultrasonic cavitation play an important role in the regeneration of activated carbon. And optimum ultrasonic treatment time is determined (5 min). In addition, the preparation of cu-loaded activated carbon by ultrasound-microwave method is investigated to pretreat wastewater produced in paracetamol production. The results show that Cu and Cu oxides can be loaded on activated carbon surface by ultrasonic-microwave pretreatment. Finally, the pretreatments of activated carbon by physical, chemical and physical-chemical method are investigated. The effects of the above different pretreatment methods on the structure and adsorption properties of activated carbon are compared and evaluated.
Using an environmentally friendly method to produce a stable and highly catalytically active electrocatalyst for the oxygen evolution reaction (OER) is becoming increasingly urgent. Herein, a novel bimetallic metal–organic framework (MOF), specifically a copper–cobalt 1, 3, 5-benzenetricarboxylate (Cu–Co-BTC) MOF, was successfully prepared by employing the gas–solid two-phase flow (GSF) synthetic technique. The as-prepared Cu–Co-BTC with its multiple active sites afforded a current density of 10 mA cm−2 at 239 mV for the OER in a 1 mol L−1 KOH solution, and showed a better electrocatalytic performance than did single-metal-containing Cu-BTC and Co-BTC materials. This work provides a new idea, one involving using novel gas–solid phase reactions for the preparation of electrocatalysts in large quantities.