César Manuel Valencia Castillo

César Manuel Valencia Castillo

Auto-generated profile, based on publicly available information

César Manuel Valencia Castillo

CARHS

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 August 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JMJulio A. Mendoza-Escamilla
Julio A. Mendoza-Escamilla
FRFrancisco Josué Hernandez Rangel
Francisco Josué Hernandez Rangel
PAPedro Cruz Alcantar
Pedro Cruz Alcantar
ZSZenaida Saavedra
Zenaida Saavedra
JMJosefa Morales
Josefa Morales
FMFrancisco J. Martinez-Lopez
Francisco J. Martinez-Lopez
Worldwide, the shortage of fresh water has increased exponentially due to population growth and contamination of available water, especially in water tables that provide water for general consumption. One of the main pollutants of water is arsenic (As), present in the environment and in most mining/metallurgical processes, which is a major health risk, especially as a carcinogen. In the region of Matehuala, San Luis Potosi (SLP), Mexico, a highly productive mining area, arsenic concentrations of 138.1 mg/kg have been found in soils—6.2 times higher than what is allowed in domestic soils, while in water it is reported up to 158 mg/L, exceeding permissible limits for human consumption. In addition to As pollution, the region suffers from water shortage both in the city and in rural communities. Therefore, it is necessary to explore new technologies to provide the population with fresh water. This paper presents a feasibility study on the use of an atmospheric water generator (AWG) to capture fresh water in the region of Matehuala, SLP. The region was found to have the necessary environmental conditions to use AWGs, with an annual average relative humidity (RH) of approximately 60%. Using a mathematical model of a dehumidifier, water harvesting can be evaluated under the region’s prevailing climatic conditions. The month with lowest harvest was found to be January, with 0.89 to 3.6 L/day, while the month with largest harvest was August at 3.9 to 18 L/day and water production costs of 0.0093 and $ 0.038 USD/L, respectively. The study concludes that the use of AWGs would help alleviate water shortages, thus benefiting marginalized people or communities, preserving ecosystems and the environment.

15 September 2024 in Applied Thermal Engineering
Verified
Journal Article
Closed access
CVCésar M. Valencia-Castillo
César M. Valencia-Castillo
GZGiuseppe Zummo
Giuseppe Zummo
LSLuca Saraceno
Luca Saraceno
JRJosé L. Rodríguez-Muñoz
José L. Rodríguez-Muñoz
FNFelipe Noh
Felipe Noh
PCPedro Cruz-Alcántar
Pedro Cruz-Alcántar

2 October 2023 in REVISTA DE CIENCIAS TECNOLÓGICAS
Verified
Journal Article
Open access
PDF file
JMJosefa Morales Morales
Josefa Morales Morales
Horacio Bautista-SantosHoracio Bautista-Santos
Horacio Bautista-Santos
Rafael Alfonso Figueroa DíazRafael Alfonso Figueroa Díaz
Rafael Alfonso Figueroa Díaz
CCCésar Manuel Valencia Castillo
César Manuel Valencia Castillo
MGMauricio Leonel Paz González
Mauricio Leonel Paz González
PAPedro Cruz Alcantar
Pedro Cruz Alcantar
In Mexico the development of remote laboratories is incipient, in 2020 the National Council of Humanities, Sciences, and Technologies (CONAHCYT) created a network of virtual laboratories with nine of its public research centers in order to create a virtual space that enables the development of experimental and research activities in a distance modality. However, access to virtual laboratories is limited only to its members, and the platforms are still under development. With this motivation, this article presents a multi-institutional project for the design, development, and implementation of a pico-hydraulic system for small-scale power generation for teaching and training purposes with the aim of responding to the current need for distance or virtual teaching of practical knowledge due to the coronavirus disease (COVID‑19) caused by the SARS-CoV-2 virus. For the development of the system, technological innovation tools (QFD, TRIZ) were used, with which the design requirements were obtained considering the users (students and teachers) and the renewable energy-related competence of the curricula. Finally, the satisfaction of the users (students and teachers) with the use of the designed system shows the advantage of including it as part of the practical activities of the subjects to improve the development of power generation, transformation, and transmission system projects.

1 April 2023 in REVISTA DE CIENCIAS TECNOLÓGICAS
Verified
Journal Article
Open access
PDF file
CVCésar Manuel Valencia-Castillo
César Manuel Valencia-Castillo
GZGiuseppe Zummo
Giuseppe Zummo
LSLuca Saraceno
Luca Saraceno
FNFelipe Noh
Felipe Noh
PAPedro Cruz Alcantar
Pedro Cruz Alcantar
Flow boiling into micro-channels is a good option of cooling solutions for electronic devices. Numerical simulations allow designing correctly before manufacturing. In this paper, the results of a steady-state one-dimensional simulation are presented for a single horizontal circular 1-mm tube. Through the refrigerant flows, two regions are distinguished: subcooled liquid flow and two-phase flow. Typical equations and correlations have been used for subcooled liquid flow; while one theoretical model has been used for two-phase flow. The results presented here are those by using perfluorohexane, which is used in the formulation of FC-72, a refrigerant for cooling electronic devices. For the range of tested parameters, the next conclusions come: i) from the point of view of choosing the pump, the highest subcooled level, and inlet pressure should be preferred; ii) in order to avoid the critical heat flux condition, the lowest inlet pressure should be preferred; iii) there is a contradiction for choosing the right inlet pressure because is opposite for the point of view of pump selection and critical heat flux condition.

2 October 2023 in REVISTA DE CIENCIAS TECNOLÓGICAS
Verified
Journal Article
Open access
PDF file
JRJosé-Luis Rodríguez-Muñoz
José-Luis Rodríguez-Muñoz
CCCésar Manuel Valencia Castillo
César Manuel Valencia Castillo
JPJOSE SERGIO PACHECO-CEDEÑO
JOSE SERGIO PACHECO-CEDEÑO
FNFelipe Noh
Felipe Noh
CSCarlos Ernesto Borja Soto
Carlos Ernesto Borja Soto
El presente trabajo compara las propiedades termodinámicas, del agua saturada y sobrecalentada, obtenidas mediante correlaciones propuestas por dos grupos de autores contra aquellas correlaciones obtenidas por la IAPWS. Además, el COP de un ciclo de refrigeración por absorción es estimado, en el que es empleado como mezcla de trabajo, para distintas efectividades del intercambiador de calor de solución, mediante el uso de dichas correlaciones. Los resultados muestran que, al comparar las propiedades, estimadas por medio de las correlaciones propuestas, contra las obtenidas por la IAPWS, se concluye que hay una buena concordancia entre la mayoría de propiedades bajo estudio. Cuando se utilizan las correlaciones para estimar el COP del ciclo, las correlaciones propuestas por uno de los dos grupos de autores lo estiman muy bien, siendo la máxima desviación de cuando la efectividad del intercambiador de calor de solución es de ; mientras que, si se utilizan las correlaciones propuestas por el otro grupo de autores, la desviación es casi constante, promediando . Finalmente, una ventaja del uso de las correlaciones propuestas por ambos autores, en comparación con las obtenidas por la IAPWS, es que estas resultan de formulaciones de simples polinomios (n 6), lo que las hace más sencillas de programar, así como su posible implementación como herramienta computacional para el cálculo de las propiedades del agua durante el análisis y simulación de sistemas de refrigeración por absorción.

1 July 2023 in REVISTA DE CIENCIAS TECNOLÓGICAS
Verified
Journal Article
Open access
PDF file
JRJosé-Luis Rodríguez-Muñoz
José-Luis Rodríguez-Muñoz
JPJOSE SERGIO PACHECO-CEDEÑO
JOSE SERGIO PACHECO-CEDEÑO
CCCésar Manuel Valencia Castillo
César Manuel Valencia Castillo
José de Jesús Ramírez-MinguelaJosé de Jesús Ramírez-Minguela
José de Jesús Ramírez-Minguela
This paper shows an energy and exergy analysis of an ejector-compression refrigeration cycle, in which two heat exchangers are included to the system: 1) between the condenser and liquid separator (IHX-1) and 2) between the condenser and the evaporator (IHX-2), which is an alternative configuration proposed and this configuration is defined as ERC+IHX-1+IHX-2. The effect of evaporation temperature and the heat exchanger effectiveness on the energy and exergy efficiencies and the irreversibilities of each component of the cycle have been analyzed for refrigeration and air conditioning applications. The results show that for the alternative configuration and an effectiveness of IHX-1=80%, it results slightly with a higher COP than when the configurations work with an effectiveness of IHX-2=80%. However, the exergy efficiency increases when the evaporation temperature decreases. The components that show the highest contribution to the irreversibilities in the ERC+IHX-1+IHX-2 configuration are: the condenser, the compressor and the evaporator; whereas that the lowest contribution is due to the expansion valve and IHX-1. In addition, the alternative configuration proposed presents a higher exergetic efficiency and lower irreversibilities than the configurations ERC+IHX-1 y ERC+IHX-2 reported in the literature.