A hybrid fin/planar lateral double-diffused MOSFET (LDMOS) design (hybrid FET) is proposed for the high-voltage input-output devices in a FinFETbased system-on-chip (SoC) technology. 3-D technology computer-aided design simulations show that a planar drift region and a planar drain region are advantageous for higher breakdown voltage (BV) to specific on-state resistance (R on_sp ) ratio (BV 2 /R on_sp ). By slightly extending the planar portion of the semiconductor active region into the gated channel region, the theoretical limit of BV 2 /R on_sp for LDMOS can be surpassed. Hybrid FETs can be fabricated using a process flow that is compatible with the state-of-art FinFET SoC technology.
10 November 2016 in IEEE Transactions on Electron Devices
Tilted ion implantation (TII) can be used in conjunction with pre-existing masking features on the surface of a substrate to form features with smaller dimensions and smaller pitch. In this paper, the resolution limit of this sub-lithographic patterning approach is examined via experiments as well as Monte Carlo process simulations. TII is shown to be capable of defining features with size below 10 nm, in a self-aligned manner, reproducing with high fidelity the line-edge roughness of the pre-existing masking features. Since it has relatively low associated process cost, TII-enhanced patterning is a promising approach to advance high-volume manufacture of integrated circuits beyond the 7-nm technology node.
A scheme for controllably adjusting transistor drive strength in inserted-oxide FinFET (iFinFET) technology is proposed, to enable cell ratio tuning for a minimally sized six-transistor (6T) SRAM cell. Specifically, one or more of the stacked nanowire channels within an iFinFET can be made to be essentially non-conducting by ion implantation to increase its threshold voltage. Via 3-D device simulations and a calibrated compact $I$ – $V$ model, this scheme is projected to enable more than 0.1 V reduction in minimum cell operating voltage ( $V_{\mathrm {MIN}})$ for a 6T SRAM high-density cell design.
The 3D NPN transistor model is established with TCAD software, and the ionization/displacement synergistic effect is simulated. The simulation result verified that the gain degradation caused by the synergistic effect is more serious than the simple sum of the ionization and displacement effects. The influence of the transistor emitter and base area processes on the synergistic effect is simulated and analyzed. The results show that increasing the emitter perimeter/area ratio, deepening the emitter junction depth, increasing the base doping concentration, and widening the neutral base width will aggravate the synergistic radiation effect and make the gain degradation more serious, which could provide theoretical suggestions for the design of anti-radiation reinforcement. Especially, the sensitivity of the ionizing radiation effect and the displacement radiation effect to the base doping concentration are opposite. The proportion of the two kinds of radiation damage in the synergistic effect should be considered when evaluating the sensitivity of the synergy effect to the doping concentration of the transistor base region.