Adding silicon (Si) to graphite (Gr) anodes is an effective approach for boosting the energy density of lithium‐ion batteries, but it also triggers mechanical instability due to Si volume changes upon (de)lithiation reactions. In this work, component‐specific (de)lithiation dynamics on Si‐rich (30 and 70 wt.% Si) SiGr anodes at various charge/discharge C‐rates are unveiled and compared to a graphite‐only electrode (100Gr) via operando synchrotron X‐ray diffraction coupled with differential capacity plots analysis. Results show preferential lithiation of amorphous Si above ≈200 mV and competing lithiation of Gr, amorphous Si, and crystalline Si below ≈200 mV. Discharge proceeds via sequential delithiation of Gr and amorphous lithium silicide. Si shifts the interconversion potentials of graphite intercalation compounds, lowering the Gr state of charge compared to 100Gr. In the 30% Si electrode, crystalline Si amorphization at potentials <110 mV is found to be kinetically hindered at C‐rates higher than C/5, which can be key for enhancing the cycling stability of SiGr anodes. The 70% Si electrode exhibits restricted lithium diffusion in Gr, full Si amorphization, and Li15Si4 formation. These findings related to the potential‐ and current‐dependent dynamic changes on SiGr blends are crucial for designing stable high energy density SiGr anodes.
Lithium‐ion capacitors (LICs) represent promising high‐power energy storage devices, most commonly composed of a lithium‐ion intercalation anode (e. g., graphite or hard carbon), a supercapacitor activated carbon (AC) cathode, and an electrolyte with 1 M LiPF6 in carbonate solvents. LiPF6 is susceptible to hydrolysis, forming HF, which leads to challenges for disassembly and recycling, risks during hazardous events, and extensive energy consumption during production. Here, we report on the feasibility of replacing LiPF6 with the non‐hydrolysing salt LiFSI for use with AC electrodes. Based on voltage hold measurements in a half‐cell setup, good long‐term stability is achieved with an upper cut‐off voltage of 3.95 V vs. Li/Li+, potentially enabling cell voltages of ~3.8 V when combined with graphite or silicon‐based anodes (operating at ~0.1 V vs. Li/Li+) in LIC full cells. The lower cut‐off voltage was determined to be 2.15 V vs. Li/Li+. The systematic comparison of CV, leakage current analysis and capacity retention upon voltage hold highlights the importance of the latter method to provide a realistic assessment of the electrochemical stability window (ESW) of LiFSI on a commercial AC electrode. The morphological and surface‐chemical post‐mortem analysis of AC electrodes used with LiFSI revealed that the oxidation of the FSI anion, as evidenced by the presence of new S 2p and N 1s features in the XPS spectra, and an increasing number of oxygenated species on the AC were the main processes causing capacity fade at positive polarization.