This study investigates the elastic response characteristics of a floating wind turbine (FOWT) with two vertical-axis wind turbines (VAWTs), called double-rotor VAWTs. The model consists of two VAWTs mounted on a single semi-submersible floating structure and employs a single point mooring, which allows the FOWT to always self-align with the wind. Usually, a coupled analysis of the wind turbine and floating structure is used in the design of FOWTs; however, there is no coupled analysis available for VAWTs. In this study, we attempted to combine the wind turbine design software “QBlade” and the coupled wind turbine/floating body analysis code “UTWind” as one of the methods of coupled analysis of a VAWT and a floating body. Numerical simulation results were compared with experimental results using an elastic model scaled down to 1/100 of its actual model to determine the motion response and cross-sectional bending moments. The experimental results showed that the thrust of the VAWT had a particular influence on the cross-sectional forces and motion response between the two VAWTs. For cross-sectional forces, all results showed similar trends. Overall, the results of UTWind for double-rotor VAWTs are reasonable. It was also found that the pitch motion must be accurately reproduced to improve the accuracy.
A Quadmaran vessel is a maritime navigation vessel with four hulls, and is expected to be utilized for high-density water quality observation in aquaculture farms. The performance of the vessel during dynamic positioning (DP) is integral to the accuracy of collected data. However, there are no models available to understand the motion characteristics of the multi-hull vessels in DP mode. Therefore, a computational model was developed to predict the DP motion of the Quadmaran vessel based on quasi-static assumptions. The fluid forces on the hulls, the thrust force of the propellers, and the external wind forces are modelled systematically, assuming the average speed while in DP does not exceed 0.25 m/s. A series of oblique towing tests and static turning tests were conducted on a 1/3 scale model to determine the hydrodynamic coefficients, while the Propeller Open Test was conducted to survey the propeller performance. The wind load was also incorporated into the computational model. Experimental validation tests were conducted in calm water and actual sea areas, and the correlation between experiment and simulation results was good. We concluded that the computational model can predict the DP motion of the Quadmaran vessel with an accuracy of roughly 2 m.
27 April 2023 in Journal of Ocean Engineering and Marine Energy