Laboratory‐based X‐ray absorption spectroscopy (XAS) and especially X‐ray absorption near‐edge structure (XANES) offers new opportunities in catalyst characterization and presents not only an alternative, but also a complementary approach to precious beamtime at synchrotron facilities. We successfully designed a laboratory‐based setup for performing operando, quasi‐simultaneous XANES analysis at multiple K‐edges, more specifically, operando XANES of mono‐, bi‐, and trimetallic CO2 hydrogenation catalysts containing Ni, Fe, and Cu. Detailed operando XANES studies of the multielement solid catalysts revealed metal‐dependent differences in the reducibility and re‐oxidation behavior and their influence on the catalytic performance in CO2 hydrogenation. The applicability of operando laboratory‐based XANES at multiple K‐edges paves the way for advanced multielement catalyst characterization complementing detailed studies at synchrotron facilities.
In lithium ion batteries (LIBs), the layered cathode materials of composition LiNi1−x−yCoxMnyO2 are critical for achieving high energy densities. A high nickel content (>80%) provides an attractive balance between high energy density, long lifetime, and low cost. Consequently, Ni‐rich layered oxides cathode active materials (CAMs) are in high demand, and the importance of LiNiO2 (LNO) as limiting case, is hence paramount. However, achieving perfect stoichiometry is a challenge resulting in various structural issues, which successively impact physicochemical properties and result in the capacity fade of LIBs. To better understand defect formation in LNO, the role of the Ni(OH)2 precursor morphology in the synthesis of LNO requires in‐depth investigation. By employing aberration‐corrected scanning transmission electron microscopy, electron energy loss spectroscopy, and precession electron diffraction, a direct observation of defects in the Ni(OH)2 precursor preparedis reported and the ex situ structural evolution from the precursor to the end product is monitored. During synthesis, the layered Ni(OH)2 structure transforms to partially lithiated (non‐layered) NiO and finally to layered LNO. The results suggest that the defects observed in commercially relevant CAMs originate to a large extent from the precursors, hence care must be taken in tuning the co‐precipitation parameters to synthesize defect‐free Ni‐rich layered oxides CAMs.