23 November 2021 in Journal of Applied Physics
Heterogeneous integration of β-(SnxGa1−x)2O3 (TGO) UV-C photodetectors on silicon substrates by molecular beam epitaxy is demonstrated. Multimodal electron microscopy and spectroscopy techniques reveal a direct correlation between structural, compositional, and optical properties of TGO and the functional properties of the photodetectors. Wavelength dispersive x-ray spectroscopy results accurately determine Sn concentrations (x) in the region of 0.020, and room temperature cathodoluminescence (CL) hyperspectral imaging shows changes in the CL emission intensity in TGO compared with a Ga2O3 sample with no Sn. Alloying Ga2O3 with Sn is shown to quench the red emission and enhance the blue emission. The increase in blue emission corresponds to the rise in VGa-related deep acceptors responsible for the high gain observed in the TGO detectors. A Ga2O3 nucleation layer is shown to improve the TGO surface quality and give better device properties compared to TGO grown directly onto the Si substrate, including a higher specific detectivity on the order of 1012 Jones.
5 July 2021 in Microscopy and Microanalysis
Wavelength-dispersive X-ray (WDX) spectroscopy was used to measure silicon atom concentrations in the range 35–100 ppm [corresponding to (3–9) × 1018 cm−3] in doped AlxGa1–xN films using an electron probe microanalyser also equipped with a cathodoluminescence (CL) spectrometer. Doping with Si is the usual way to produce the n-type conducting layers that are critical in GaN- and AlxGa1–xN-based devices such as LEDs and laser diodes. Previously, we have shown excellent agreement for Mg dopant concentrations in p-GaN measured by WDX with values from the more widely used technique of secondary ion mass spectrometry (SIMS). However, a discrepancy between these methods has been reported when quantifying the n-type dopant, silicon. We identify the cause of discrepancy as inherent sample contamination and propose a way to correct this using a calibration relation. This new approach, using a method combining data derived from SIMS measurements on both GaN and AlxGa1–xN samples, provides the means to measure the Si content in these samples with account taken of variations in the ZAF corrections. This method presents a cost-effective and time-saving way to measure the Si doping and can also benefit from simultaneously measuring other signals, such as CL and electron channeling contrast imaging.
25 May 2022 in Microscopy and Microanalysis
The impact of secondary fluorescence on the material compositions measured by X-ray analysis for layered semiconductor thin films is assessed using simulations performed by the DTSA-II and CalcZAF software tools. Three technologically important examples are investigated: AlxGa1−xN layers on either GaN or AlN substrates, InxAl1−xN on GaN, and Si-doped (SnxGa1−x)2O3 on Si. Trends in the differences caused by secondary fluorescence are explained in terms of the propensity of different elements to reabsorb either characteristic or bremsstrahlung X-rays and then to re-emit the characteristic X-rays used to determine composition of the layer under investigation. Under typical beam conditions (7–12 keV), the quantification of dopants/trace elements is found to be susceptible to secondary fluorescence and care must be taken to prevent erroneous results. The overall impact on major constituents is shown to be very small with a change of approximately 0.07 molar cation percent for Al0.3Ga0.7N/AlN layers and a maximum change of 0.08 at% in the Si content of (SnxGa1−x)2O3/Si layers. This provides confidence that previously reported wavelength-dispersive X-ray compositions are not compromised by secondary fluorescence.