Research Centre for Nano-Materials and Energy Technology, School of Science and Technology, Sunway University, Bandar Sunway, Subang Jaya, Selangor, 47500, Malaysia
Auto-generated profile, based on publicly available information
Jesbains Kaur
Research Centre for Nano-Materials and Energy Technology, School of Science and Technology, Sunway University, Bandar Sunway, Subang Jaya, Selangor, 47500, Malaysia
The annealing of an AlN buffer layer in a carbon-saturated N2–CO gas on a sapphire substrate was investigated. The crystal quality of the buffer layer was significantly improved by annealing at 1650–1700 °C. An AlN buffer layer with a thickness of 300 nm was grown by metalorganic vapor phase epitaxy (MOVPE), and was annealed at 1700 °C for 1 h. We fabricated a 2-µm-thick AlN layer on the annealed AlN buffer layer by MOVPE. The full widths at half maximum of the (0002)- and ( )-plane X-ray rocking curves were 16 and 154 arcsec, respectively, and the threading dislocation density was 4.7 × 108 cm−2.
1 May 2018 in International Communications in Heat and Mass Transfer
The microstructure of an AlN template after high-temperature annealing was investigated by transmission electron microscopy (TEM). The AlN template was prepared by depositing an AlN layer of about 200 nm thickness on a sapphire (0001) substrate by metal–organic vapor phase epitaxy. The AlN template was annealed under (N2 + CO) atmosphere at 1500–1650 °C. TEM characterization was conducted to investigate the microstructural evolution, revealing that the postannealed AlN has a two-layer structure, the upper and lower layers of which exhibit Al and N polarities, respectively. It has been confirmed that postannealing is an effective treatment for controlling the microstructure.
16 January 2019 in IOP Conference Series: Materials Science and Engineering
A numerical investigation on melting of Phase Change Material (PCM) after dispersed with various types of nanoparticles is presented in this study. Nanoparticles with high thermal conductivity properties could be a good additive to enhance the thermal performance of PCM in latent heat thermal energy storage. This paper focus on the melting rate of paraffin wax as PCM dispersed with three types of nanoparticles: Alumina (Al2O3), Copper oxide (CuO) and Zinc Oxide (ZnO) in a 25mm × 25mm square enclosure. The effect of heating side of the wall and the concentration of nanoparticles dispersed in PCM were investigated. ANSYS Workbench 17.0 that included mesh generation tools and FLUENT software was used to run the simulation. Enthalpy porosity method was applied in this numerical study. Results shown that heat transfer rate was improved by adding low volume fraction of nanoparticles. Heating from the side wall of the enclose has better melting rate than heating from below.