24 March 2016 in Japanese Journal of Applied Physics
This paper reports the first demonstration of 300 mm In0.53Ga0.47As-on-insulator (InGaAs-OI) substrates. The use of direct wafer bonding and the Smart Cut™ technology lead to the transfer of high quality InGaAs layer on large Si wafer size (300 mm) at low effective cost, taking into account the reclaim of the III–V on Si donor substrate. The optimization of the three key building blocks of this technology is detailed. (1) The III–V epitaxial growth on 300 mm Si wafers has been optimized to decrease the defect density. (2) For the first time, hydrogen-induced thermal splitting is made inside the indium phosphide (InP) epitaxial layer and a wide implantation condition ranges is observed on the contrary to bulk InP. (3) Finally a specific direct wafer bonding with alumina oxide has been chosen to avoid outgas diffusion at the alumina oxide/III–V compound interface.
18 July 2022 in Physical Review Research
Efficient and cost-effective Si-compatible lasers are a longstanding wish of the optoelectronic industry. In principle, there are two options. For many applications, lasers based on III-V compounds provide compelling solutions, even if the integration is complex and therefore costly. However, where low costs and also high integration density are crucial, group-IV-based lasers—made of Ge and GeSn, for example—could be an alternative, provided their performance can be improved. Such progress will come with better materials but also with the development of a more profound understanding of their optical properties. In this work, we demonstrate, using Ge microbridges with strain up to 6.6%, a powerful method for determining the population inversion gain and the material and optical losses of group IV lasers. This is done by deriving the values for the injection carrier densities and the cavity losses from the measurement of the change of the refractive index and the mode linewidth, respectively. We observe a laser threshold consistent with optical gain. Material loss values are obtained from a tight-binding calculation. Lasing in Ge—at steady-state—is found to be limited to low temperatures in a narrow regime of tensile strain at the crossover to the direct-band-gap band structure. We explain this observation by parasitic inter-valence-band absorption that increases rapidly with higher injection densities and temperature. -doping seems to reduce the material loss at low excitation, but it does not extend the lasing regime. We also discuss the impact of the optically inactive carriers in the L-valley on the linewidth of group IV lasers.
21 August 2024 in Materials Science Forum
SmartSiC™ products developed by Soitec in the past four years consist of a high quality monocrystalline silicon carbide (m-SiC) on the top of an ultra-low resistivity polycrystalline silicon carbide (p-SiC or poly-SiC), the interface being electrically conductive. These engineered substrates are intended to bring added value for vertical power devices compared to standard m-SiC, by leveraging the wide bandgap (WBG) properties of the m-SiC and the enhanced p-SiC properties of the base substrate. Thus, it is of paramount importance to understand and monitor the p-SiC properties. In this paper, we present its electrical resistivity, microstructure and texture measurements through SEM and EBSD, thermal conductivity through Laser Flash Anneal (LFA), and Young modulus measurements.