17 March 2021 in IEEE Transactions on Industrial Electronics
This article demonstrates a vibration test for a resonant MEMS scanning system in operation to evaluate the vibration immunity for automotive lidar applications. The MEMS mirror has a reinforcement structure on the backside of the mirror, causing vibration coupling by a mismatch between the center of mass and the rotation axis. An analysis of energy variation is proposed, showing the direction dependency of vibration coupling. Vibration influences are evaluated by transient vibration response and vibration frequency sweep using a single tone vibration for translational y- and z- axis. The measurement results demonstrate standard deviation (STD) amplitude and frequency errors are up to 1.64% and 0.26%, respectively, for 2 $g_\text {rms}$ single tone vibrations on y axis. The simulation results also show a good agreement with both measurements, proving the proposed vibration coupling mechanism of the MEMS mirror. The phased locked loop (PLL) improves the STD amplitude and frequency errors to 0.91% and 0.15% for y axis vibration, corresponding to 44.4% and 43.0% reduction, respectively, showing the benefit of a controlled MEMS mirror for reliable automotive MEMS lidars.
25 March 2020 in IEEE Transactions on Industrial Electronics
This paper presents a novel method to derive and identify an accurate small perturbation model of a comb-actuated resonant MEMSmirror with highly nonlinear dynamics. Besides the nonlinear stiffness and damping, the comb-drives add nonlinearities due to their electrostatic nature and their effect on the dynamic mirror amplitude over frequency behavior. The proposed model is based on a period to period energy conservation and applies for most nonlinearities present in an oscillator such as MEMS mirrors. It is shown that for specific nominal operation points with square wave excitation, the small perturbation model is linear for a wide range. The full dynamics of the derived linear model are parametrized by three constants, that can be estimated by the PLL, performing a proposed identification method only based on phase measurements. An analysis of control laws usually applied in a PLL provides important information for the proper design of controllers to meet the desired behavior for individual applications.
16 August 2021 in Optics Express
This paper proposes a phase modulation method for Lissajous scanning systems, which provides adaptive scan pattern design without changing the frame rate or the field of view. Based on a rigorous analysis of Lissajous scanning, phase modulation constrains and a method for pixel calculation are derived. An accurate and simple metric for resolution calculation is proposed based on the area spanned by neighboring pixels and used for scan pattern optimization also considering the scanner dynamics. The methods are implemented using MEMS mirrors for verification of the adaptive pattern shaping, where a 5-fold resolution improvement in a defined region of interest is demonstrated.
1 September 2021 in Journal of Microelectromechanical Systems
This contribution presents charge-based capacitive self-sensing with a continuous full state observer for a parametrically driven resonant electrostatic 1D MEMS mirror considering precise and seamless estimation. Based on current integrators, series capacitances or a capacitance network the direct charge self-sensing principles are investigated and compared considering leakage currents, precision and a minimum implementation effort. In comparison to the other charge sensing methods, the proposed methods directly measure the charge changes while the drive voltage is switched on. Since resonant MEMS mirrors are driven by a rectangular signal, the direct self-sensing implies a lack of data when the drive voltage is switched off. A nonlinear observer is also proposed to estimate the full mirror state continuously based on an identified MEMS mirror model. The capacitive charge self-sensing methods achieve overall a high sensing precision of less than 0.14 % RMSE and the observer estimation error of the full state is below 1 % peak-to-peak error regardless of the availability of the charge self-sensing measurements, demonstrates accurate continuous full state estimation. [2021-0130]
1 November 2020 in Mechatronics
1 October 2021 in Mechatronics