While nanopositioners often use flexures for high quality motion avoiding nonlinearities, the achievable motion range and energy efficiency are limited due to the force required for positioning against the flexures. To overcome the problem, this paper proposes a flexure-guided nanopositioner with a nonlinear hybrid reluctance actuator for a large range and energy efficiency. The actuator has nonlinear negative stiffness that partially cancels the flexures' stiffness. Consequently, the nonlinearities reduce the required current by up to 67%. To compensate them for high-precision motion in the entire range of 2 mm, a feedback controller is designed, achieving a closed-loop bandwidth of 640 Hz and positioning resolution of 2.48 nm(RMS). The mechatronic system is designed such that the flexure nonlinearity has no influence on the closed-loop stability and bandwidth. Additionally for accurate periodic scanning motion, modeling-free inversion-based iterative control is combined to decrease the tracking error by a factor of 396 at most. The achieved error is 10 nm(RMS) for a 1 Hz triangular motion of 1.6 mm range and for a 100 Hz triangular motion of 10 μm range. The results demonstrate that the proposed nanopositioner can play a role of both long-stroke and high-speed scanners with the improved power consumption.
20 August 2018 in IEEE/ASME Transactions on Mechatronics
This paper presents the design, assembly, and evaluation of a novel integrated two degree of freedom (2DoF) actuator design for tip/tilt motion and its integration into a fast steering mirror with comparably large range. The system is designed for scanning applications, such as in optical metrology systems, and comprises an integrated symmetric 2DoF hybrid-reluctance-force actuator and mover-flexure-design. The actuator design employs a permanent magnet for biasing the actuator with a constant flux and two actuator coils per axis to generate a steering flux for positioning the mover. The system prototype has an angular range of $\pm 3^\circ$ in tip and tilt and achieves a closed-loop control bandwidth of 1 kHz based on the signal of eddy current sensors. Compared to the only so far realized state-of-the-art reluctance force actuated fast steering mirror system with integrated sensors, the presented design enables to improve the product of range times’ bandwidth, representing a measure for the system performance, by more than 85%.
This article demonstrates a vibration test for a resonant MEMS scanning system in operation to evaluate the vibration immunity for automotive lidar applications. The MEMS mirror has a reinforcement structure on the backside of the mirror, causing vibration coupling by a mismatch between the center of mass and the rotation axis. An analysis of energy variation is proposed, showing the direction dependency of vibration coupling. Vibration influences are evaluated by transient vibration response and vibration frequency sweep using a single tone vibration for translational y- and z- axis. The measurement results demonstrate standard deviation (STD) amplitude and frequency errors are up to 1.64% and 0.26%, respectively, for 2 $g_\text {rms}$ single tone vibrations on y axis. The simulation results also show a good agreement with both measurements, proving the proposed vibration coupling mechanism of the MEMS mirror. The phased locked loop (PLL) improves the STD amplitude and frequency errors to 0.91% and 0.15% for y axis vibration, corresponding to 44.4% and 43.0% reduction, respectively, showing the benefit of a controlled MEMS mirror for reliable automotive MEMS lidars.