A porous structure is widely used in additive manufacturing of orthopedic implants to reduce the stiffness mismatch between the implant and the bone. The development and improvement of porous structures for orthopedic implants is still a major challenge. It is essential to study mechanical properties of different porous structures and their relation to the deformation mechanism. In this paper, the relation between the deformation mechanism and the mechanical properties of Ti6Al4V triply periodic minimal surface (TPMS) structures, such as stretching-dominated IWP and bending-dominated gyroid structures, are investigated using the finite element analysis for uniform and density gradient scaffolds. The method for designing network-based and sheet-based TPMS structures is presented. The numerical results show that failure in the stretching-dominated structure (IWP) starts with buckling of the vertical struts, whereas failure in the bending-dominated structure (gyroid) occurs with the formation of the 45° shear band. The gyroid structure shows a higher shear modulus than the IWP structure. The numerical results exhibit good agreement with the previous experimental data for uniform and density gradient structures. Finally, the effect of the void defect on the elastic and shear moduli is evaluated. The results indicate that the elastic modulus of the bending-dominated structure shows a greater reduction in the presence of void defects than that of the stretching-dominated structure, and the shear modulus of the stretching-dominated structure is more sensitive to void defects than that of the bending-dominated structure.
Auxetic structures made of biodegradable polymers are favorable for industrial and daily life applications. In this work, poly(butylene adipate-co-terephthalate) (PBAT) is chosen for the study of the deformation behavior of an inverse-honeycomb auxetic structure manufactured using the fused filament fabrication. The study focus is on auxetic behavior. One characteristic of polymer deformation prediction using finite element (FE) simulation is that no sounded FE model exists, due to the significantly different behavior of polymers under loading. The deformation behavior prediction of auxetic structures made of polymers poses more challenges, due to the coupled influences of material and topology on the overall behavior. Our work presents a general process to simulate auxetic structural deformation behavior for various polymers, such as PBAT, PLA (polylactic acid), and their blends. The current report emphasizes the first one. Limited by the state of the art, there is no unified regulation for calculating the Poisson’s ratio for auxetic structures. Here, three calculation ways of are presented based on measured data, one of which is found to be suitable to present the auxetic structural behavior. Still, the influence of the auxetic structural topology on the calculated Poisson’s ratio value is also discussed, and a suggestion is presented. The numerically predicted force–displacement curve, Poisson’s ratio evolution, and the deformed auxetic structural status match the testing results very well. Furthermore, FE simulation results can easily illustrate the stress distribution both statistically and local-topology particularized, which is very helpful in analyzing in-depth the auxetic behavior.