An improved pulse‐chemisorption technique is presented, which is proven to be independent of the strength of interaction between adsorptive and catalyst material. The methodology is based on the transient mass balance of the adsorptive, allowing for quantitative evaluation of the pulse‐signal obtained from the experiment. Two experimental strategies for determination of the adsorption capacity are introduced, with and without using an internal standard. The methodology is illustratively discussed based on simulation results and verified by chemisorption experiments of hydrogen and carbon dioxide on a supported nickel catalyst. In addition, temperature and dosing effects are examined and benchmarked with volumetric measurements of the adsorption capacity. The proposed mathematical evaluation method of the measured data can be applied directly to experiments performed in standard equipment for pulse‐chemisorption or in modified catalyst test rigs to measure adsorption capacity before and after reaction experiments. The technique shows potential for determination of sorption kinetics and combination with operando spectroscopy.
Various supported Ru-based catalysts have been tested for CO 2 hydrogenation under different temperatures, pressures and H 2 /CO 2 ratios. Ru/TiO 2 is found to be the most active and stable catalyst over a range of process conditions followed by Ru/ZrO 2 .
The production of liquid hydrocarbons from syngas (CO and H2) via the combined Fischer‐Tropsch (FT) synthesis and hydroprocessing (HP) is a promising strategy to provide valuable chemicals and fuels based on renewable feedstocks. High yields of liquid products are essential for industrial implementation since short‐chain side products like methane and CO2 reduce the overall carbon efficiency, which holds true especially for bi‐functional Co/zeolite catalysts. In order to investigate the influence of the support material properties on the methane and CO2 selectivities in the combined FT and HP reaction, we synthesized four well‐defined catalyst materials with similar cobalt particle sizes. The active material is supported on either meso‐ or microporous silicates or aluminosilicates. The catalytic properties are investigated in FT experiments at industrially relevant conditions (20 bar, 200–260 °C) and correlated with in situ x‐ray absorption spectroscopy results to determine the chemical environment responsible for the selectivity observed. The origin of the high methane selectivity detected for crystalline and amorphous aluminosilicate was mainly traced back to the strong cobalt‐support interactions. The high CO2 selectivity, observed only for crystalline zeolite materials, is driven by the presence of oxidized cobalt species, while the acidic support in combination with micropores and possible overcracking leads to the observed drop in the C5+ selectivity.