16 June 2016 in IEEE Transactions on Industrial Electronics
Multiterminal converters eliminate using several single-input-single-output converters and simplify their topologies and reduce their cost. In this paper, a new family of multi-input converters based on three switches leg is introduced. Inputs of the proposed converters are similar and they are topologically interchangeable and have boost or buck operation modes. The proposed converter has one output that operates as an inverter. Here, all operating modes of the proposed converters and their effects on each other are investigated, in details. Also, an appropriate switching technique for the converters is given. A detailed comparison between conventional and proposed two-input converters is also presented. A two-input, one-output prototype converter has been implemented to validate the given analyses and to verify the proposed converter's performance. The experimental results are in good agreement with the theoretical and simulated analyses.
14 March 2012 in IEEE Transactions on Industrial Electronics
In this paper, two reduced switch count topologies are introduced for independently supplying two single-phase ac loads with one inverter. Using a new three-switch leg structure recently introduced and implemented in three-phase converters, two types of dual-leg and single-leg topologies are developed which respectively are functionally comparable to two full-bridge and half-bridge inverters working independently though with a less number of semiconductor switches and hence control and gate drive circuit components. The proposed six-switch and three-switch topologies are introduced; two modes of equal frequency and different frequency operation each of its own distinctive characteristics are considered for them and their pulse width modulation schemes are elaborated. Comprehensive analyses of power loss profile and output waveform properties are conducted via simulation for the proposed inverters, and the results are compared with full-bridge and half-bridge inverters. To assess the performance of the proposed inverter topologies, working prototypes are built, and the experimental results are provided.
1 December 2020 in IEEE Transactions on Plasma Science
Due to their fast switching capabilities, silicon carbide (SiC) MOSFETs are increasingly used in high-voltage pulsed-power circuits where fast and flexible high-voltage pulses are required (e.g. for plasma-processing applications), such as in our solid-state Impedance-matched Marx generator. The turn-on time of SiC MOSFETs mainly depends on the gate-driving technique and its implementation. Therefore, many studies focus on SiC MOSFET gate-driving methods. In this article, a gate-boosting driving method that was previously proposed for IGBTs is optimized for SiC MOSFETs and applied to a very fast MOSFET to reduce turn-on time as much as possible. A prototype of the optimized gate-boosting driver was built and tested to assess its performance. The test results validate the effectiveness of the optimized gate-driving method and showed that a MOSFET turn-on time of below 2 ns is achievable at a high operating voltage and moderate current and below 3 ns for a wider range of load-current and operating-voltage conditions. Furthermore, current rise rates of 38.7 kA/μs at 356-A load current are possible. All these results are considerably faster than ever demonstrated before.
1 December 2012 in IEEE Transactions on Energy Conversion
In this paper, a new interface configuration is proposed for connecting a microsource to a weak utility. The proposed configuration simultaneously conditions the quality of the power supplied to the microgrid loads. This system employs a recently introduced reduced switch count dual-output inverter in a so-called equal frequency mode which offers its best operation features such as maximum dc bus voltage utilization and minimum device ratings. Compared to the counterpart system, the proposed configuration enjoys an integrated structure and uses less number of semiconductor switches. Moreover, it retains the desirable features of the conventional system such as ability to compensate unbalanced/sagged utility and to supply three-phase unbalanced loads with balanced and ceaseless voltage. The proposed system is introduced and its carrier-based modulation scheme is elaborated. Subsequently, a detailed study on the maximum achievable modulation index under different working conditions is carried out. The report concludes with a discussion on control of the system and its controller design. The validity of operation of the proposed system is verified through simulation.