1 June 2022 in Review of Scientific Instruments
A thrust stand is developed for testing micro-Newton level thrusters on the ground. The stand is composed of a compound pendulum that is symmetrically suspended by two thin beryllium copper strips, and it is precisely calibrated by gravity. The stiffness of the stand can be adjusted in 3 orders of magnitude by a counterweight. When the stiffness is larger than 1 Nm/rad, the stand demonstrates a fast response to thrust. The measured range of the stand reaches 1000 μN, and the noise is less than 0.1 μN/ within 1 mHz–1 Hz. To calibrate the resolution of the stand, an electrostatic force is applied to the stand with an actuator. The equivalent thrust is determined to be 0.09 μN with a standard uncertainty of 0.02 μN. Using the stand, a micro-Newton colloid thruster is tested. The output of the colloid thruster changes with the applied voltage as 0.015(1) μN/V. When changing the voltage by 50 V, the change in thrust is measured to be 0.7 μN with a standard uncertainty of 0.1 μN.
1 January 2023 in Physics of Fluids
Electrospray technology is widely used in many technological areas. The beam current of electrospray is an important parameter since it directly associates with the electrohydrodynamic behavior of the cone jet and can be precisely measured. Although how the beam current changes with other variables has been theoretically and experimentally researched, the accurate prediction of the current is still difficult. Particularly, for liquids with high electrical conductivity, Ohmic conduction is a major component of the beam current, but it is ignored in many theoretical models. In this study, the beam current components are investigated via numerical simulation developed based on hydrodynamics and electrostatics equations. Consideration of both convection and conduction currents of the cone jet affords a more accurate calculation of the total beam current. Moreover, an interpolation method is employed to solve the charge “escape” problem, providing a more accurate calculation of charges as well as the currents. The results of the numerical model are validated against experimental results, showing good agreement regarding the meniscus shape and droplet diameters. For a highly conductive ionic liquid 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl) imide, the simulated beam current also shows good agreement with the experimental data, with a maximum error of 13%. Using the improved simulation model, temperature-induced beam current fluctuations are investigated to understand how an electrospray thruster behaves with temperature variations.
1 March 2022 in Journal of Applied Physics
As an application of electrospray, electrospray thrusters are preferred to work in a steady electrohydrodynamic mode to output high-precision and adjustable thrust through controlling voltages and flow rates. However, voltages and flow rates can only be modified in a small range to avoid mode transiting, thereby limiting the thrust range. To increase the thrust, adding the number of emitters or more grids for beam acceleration is considered, but it inevitably increases mechanical complexities and risks of component failure. In this paper, electrosprays are investigated by analyzing the beam current over the time and frequency domains. Results suggest that the steady cone-jet transfers into an oscillating cone-jet with a frequency of several kHz as the flow rate increases. In the oscillating cone-jet mode, beam currents and flow rates still follow the power-law relation, which is derived for the steady cone-jet. The finding suggests that setting a desired thrust over the oscillating cone-jet mode is feasible, whose maximum thrust allowed is 2.3 times the one in the steady cone-jet mode. The calculated thrust noises of the oscillating cone-jet mode are lower than 0.1 μN/Hz0.5 in the millihertz band, which meets the requirement of most drag-free satellites. The oscillation frequency is also adjustable by changing voltages or flow rates, offering another control parameter for electrospray devices. Compared to other instable modes, the oscillating cone-jet mode demonstrates superior low-noise output and controllability, thereby making it another suitable operational mode for high-precision electrospray thrusters in addition to the steady cone-jet mode.
6 November 2026 in Acta Astronautica