29 January 2010 in IEEE Journal of Quantum Electronics
Quantum well infrared photodetectors (QWIPs) are well known for their stability, high pixel-pixel uniformity and high pixel operability which are quintessential parameters for large area imaging arrays. In this paper we report the first demonstration of the megapixel-simultaneously-readable and pixel-co-registered dual-band QWIP focal plane array (FPA). The dual-band QWIP device was developed by stacking two multi-quantum-well stacks tuned to absorb two different infrared wavelengths. The full width at half maximum (FWHM) of the midwave infrared (MWIR) band extends from 4.4-5.1 ¿m and FWHM of the long-wave infrared (LWIR) band extends from 7.8-8.8 ¿m. Dual-band QWIP detector arrays were hybridized with direct injection 30 ¿m pixel pitch megapixel dual-band simultaneously readable CMOS read out integrated circuits using the indium bump hybridization technique. The initial dual-band megapixel QWIP FPAs were cooled to 68 K operating temperature. The preliminary data taken from the first megapixel QWIP FPA has shown system NE¿T of 27 and 40 mK for MWIR and LWIR bands, respectively.
5 April 2012 in IEEE Journal of Quantum Electronics
Long-wavelength complementary barrier infrared detector (CBIRD) based on III-V material is hybridized to recently designed and fabricated 320 × 256 pixel format two-color read-out integrated circuit. The n-type CBIRD is characterized in terms of performance and thermal stability. This paper reports on the measured dark current density, noise equivalent difference temperature, quantum efficiency, responsivity, minimum resolvable difference temperature, and modulation transfer function.
27 July 2012 in IEEE Photonics Technology Letters
We report on the details of inductively coupled plasma etching for achieving low dark current long-wavelength infrared focal plane arrays (FPAs). External factors that influence the etching process are studied. A high-quality hard mask for excellent pattern transfer is discussed. Next, a suitable mounting technique for good thermal contact is described. Finally, the challenges and differences between etching large 200-μm test diodes and small 28-μm FPA pixels are discussed. The complete etching process is then demonstrated on a 320 × 256 complementary barrier infrared detector FPA. The mean dark current density of 2.2 × 10-4A/cm2 is measured at an operating bias of 128 mV with a 50% cutoff wavelength of 8.8 μm. Good imagery is achieved with an array yielding an 81% fill factor with 97% operability. Operating at T = 80 K, the measured mean noise equivalent differential temperature is 18.6 mK, and the mean detectivity is D* = 1.3 × 1011cm-Hz1/2/W.