Ecole Polytechnique Fédérale de Lausanne EPFL, School of Architecture, Civil and Environmental Engineering ENAC, Laboratory of Ecological Systems ECOS, Lausanne, Switzerland
Auto-generated profile, based on publicly available information
Paula Sanginés de Cárcer
Ecole Polytechnique Fédérale de Lausanne EPFL, School of Architecture, Civil and Environmental Engineering ENAC, Laboratory of Ecological Systems ECOS, Lausanne, Switzerland
Assessing the effect of global warming on forest growth requires a better understanding of species‐specific responses to climate change conditions. Norway spruce and European beech are among the dominant tree species in Europe and are largely used by the timber industry. Their sensitivity to changes in climate and extreme climatic events, however, endangers their future sustainability. Identifying the key climatic factors limiting their growth and survival is therefore crucial for assessing the responses of these two species to ongoing climate change. We studied the vulnerability of beech and spruce to warmer and drier conditions by transplanting saplings from the top to the bottom of an elevational gradient in the Jura Mountains in Switzerland. We (1) demonstrated that a longer growing season due to warming could not fully account for the positive growth responses, and the positive effect on sapling productivity was species‐dependent, (2) demonstrated that the contrasting growth responses of beech and spruce were mainly due to different sensitivities to elevated vapor–pressure deficits (VPD), (3) determined the species‐specific limits to VPD above which growth rate began to decline, and (4) demonstrated that models incorporating extreme climatic events could account for the response of growth to warming better than models using only average values. These results support that the sustainability of forest trees in the coming decades will depend on how extreme climatic events will change, irrespective of the overall warming trend.
The aim of this work is to investigate the slow pyrolysis of olive stones in a rotary kiln as a means to increase the fuel properties and potential use of this renewable solid fuel. The pyrolysis process takes place primarily at temperatures between 300 and 500 °C resulting in the transformation of the solid biomass into a biochar, a pyrolysis liquid (up to 38.1 wt. %) and a non-condensable gas fraction (up to 35.4 wt. %). This thermal treatment has a positive influence in the fuel properties of the solid fraction in terms of increased C content (up to 75.9 wt. %), reduced O/C and H/C ratios (down to 0.28 and 0.03), reduced volatile matter and moisture content (down to 6.9 wt. % and below 1.0 wt. %, respectively), increased fixed carbon (up to 90.2 wt. %), increased Lower Heating Value (LHVo up to 37.1 MJ/kg) and energy density (26.7 GJ/m3). The process also involved changes in the surface chemistry (increasingly hydrophobic nature) and textural properties of the solid (formation of cracks and internal voids, resulting in the development of a pore structure of up to 0.193 cm3/g and a surface area up to 507 m2/g). The condensable and gas fractions resulting from the pyrolysis process may also be used for their fuel properties. Thus, the pyrolysis liquid exhibited a high water content (62.5 wt. %), a mass density of 1.063 kg/m3, a viscosity of 1.33 cSt, and a Higher Heating Value (HHVo) of 16.9 MJ/kg. The gas fraction resulting from the pyrolysis of olive stones contains high concentrations of combustible gases like CO and H2, and lower proportions of light hydrocarbons. The gas fraction exhibited HHV up to 6.83 MJ/Nm3 due primarily to CO and H2, while the formation of light hydrocarbons was very limited. The energy distribution resulting from the pyrolysis of olive stone at 700 °C (following completion of the thermal degradation) is as follows: solid fraction 48.2%; oil fraction 11.0%; and gas fraction and energy losses (by difference) 40.8%.