The aim of this work is to investigate the slow pyrolysis of olive stones in a rotary kiln as a means to increase the fuel properties and potential use of this renewable solid fuel. The pyrolysis process takes place primarily at temperatures between 300 and 500 °C resulting in the transformation of the solid biomass into a biochar, a pyrolysis liquid (up to 38.1 wt. %) and a non-condensable gas fraction (up to 35.4 wt. %). This thermal treatment has a positive influence in the fuel properties of the solid fraction in terms of increased C content (up to 75.9 wt. %), reduced O/C and H/C ratios (down to 0.28 and 0.03), reduced volatile matter and moisture content (down to 6.9 wt. % and below 1.0 wt. %, respectively), increased fixed carbon (up to 90.2 wt. %), increased Lower Heating Value (LHVo up to 37.1 MJ/kg) and energy density (26.7 GJ/m3). The process also involved changes in the surface chemistry (increasingly hydrophobic nature) and textural properties of the solid (formation of cracks and internal voids, resulting in the development of a pore structure of up to 0.193 cm3/g and a surface area up to 507 m2/g). The condensable and gas fractions resulting from the pyrolysis process may also be used for their fuel properties. Thus, the pyrolysis liquid exhibited a high water content (62.5 wt. %), a mass density of 1.063 kg/m3, a viscosity of 1.33 cSt, and a Higher Heating Value (HHVo) of 16.9 MJ/kg. The gas fraction resulting from the pyrolysis of olive stones contains high concentrations of combustible gases like CO and H2, and lower proportions of light hydrocarbons. The gas fraction exhibited HHV up to 6.83 MJ/Nm3 due primarily to CO and H2, while the formation of light hydrocarbons was very limited. The energy distribution resulting from the pyrolysis of olive stone at 700 °C (following completion of the thermal degradation) is as follows: solid fraction 48.2%; oil fraction 11.0%; and gas fraction and energy losses (by difference) 40.8%.
20 September 2016 in Waste and Biomass Valorization
This paper presents a particular case of a pedagogically successful, dynamic, and efficient remote laboratory. The aim of the remote laboratory is to learn how to program embedded real-time systems in a real machine such as a robot. The system supplies feedback information to the user through a Web browser and an ssh terminal. Likewise, the remote laboratory allows a high degree of interaction owing to a clear and simple interface. This type of telecontrol Web-based system generates strong interest among students. The following are the two main contributions of this system: The remote laboratory allows collaboration among students in order to solve the problem, and the usage of a free software architecture allows anyone to replicate and improve the laboratory.
HYSOL technology allows the hybridization of Concentrated Solar Power (CSP) technology with biomethane for the efficient generation of clean and sustainable electricity in a firm and dispatchable manner. Biomass from horticultural residues and drought-tolerant crops is a promising feedstock for biomethane production in areas with high solar radiation. This paper investigates the biomass potential of these two resources in Spain by considering the volume of horticultural residues generated, availability of suitable land for dedicated prickly pear plantations and its methane generation capacity. Experimental biomethane yields have also been determined for different substrates mixtures of overripe tomatoes and prickly pear cladodes. Potential biomethane and electricity production are then calculated, as well as the number of conventional CSP and HYSOL plants that could be supplied with this energy. Results show that a significant number of CSP plant could be methane-supplied by the studied resources: up to 45 conventional CSP or 4 HYSOL plants