20 June 2022 in Materials Science and Engineering: A
9 February 2023 in Materials and Corrosion
30 May 2020 in Transactions of the Indian National Academy of Engineering
12 June 2026 in SSRN Electronic Journal
Austenitisation is a mainstay of steel processing and is required to form strong microstructures, e.g., martensite. It is known that austenitisation can proceed by a two-step mechanism, which first involves a 'memory effect' that regenerates the original prior-austenite grains (PAGs), and second a recrystallisation step, which generates a new grain structure. However, the mechanisms of these processes are not fully understood, especially in low-alloy steels. Here, we use in-situ high-temperature electron backscatter diffraction and synchrotron X-ray diffraction to investigate austenitisation in two martensitic low-alloy steels. Both exhibited the memory effect, but only one subsequently recrystallised. The memory effect progressed by the growth of acicular austenite consistent with a mixed displacive/diffusive reaction. Growth of pre-existing retained austenite was unlikely to be responsible for the memory effect, as memory was observed in alloys without measurable retained austenite, and multiple variants of austenite nucleated within a PAG at the transformation start. The growth of the memory variant along martensite-martensite grain boundaries was favoured over other variants. Evidence strongly suggests that the driving force for the recrystallisation step is dominated by the dislocations generated during the transformation itself, and not by those inherited from martensite. The occurrence of recrystallisation is dependent on the competition between dislocation recovery and recrystallisation in memory orientation austenite, which is influenced by an alloy’s austenitisation temperature, and heating rates through austenitisation. This new understanding may enable improved heat treatment practices that exploit the two-step nature of the process to promote improved PAG.
14 July 2026 in SSRN Electronic Journal
High-temperature oxidation of Alloy 800HT in impure helium can affect structural integrity through grain-boundary-controlled subsurface degradation. This study compared oxidation behaviour at 800°C between a P600-ground surface, containing a deformation-induced ultrafine-grained layer (UFGL), and a deformation-free Oxide Polishing Suspension (OPS)-polished surface representing the bulk microstructure. Grinding accelerated chromia formation, yielding a thin, unprotective, continuous scale. However, the UFGL recrystallised during exposure, generating grain boundaries susceptible to preferential intergranular oxidation (PIO). Both surfaces converged to a long-term degradation mode governed by bulk grain-boundary character, with non-Σ3 boundaries promoting PIO while Σ3 boundaries largely arrested penetration. Bowed grain boundary morphologies were consistent with diffusion-induced grain boundary migration (DIGM) as a plausible PIO precursor, though Ni/Cr solute partitioning was not retained after prolonged homogenisation. These findings demonstrate that surface finish influences oxidation only transiently, whereas long-term environmental degradation, is dictated by the intrinsic grain‐boundary network, with important implications for crack‐initiation susceptibility under stress.