16 January 2025 in Optics Letters
We present the first, to our knowledge, demonstration of a 1550 nm multi-wavelength distributed feedback (MW-DFB) laser employing a third-order, four-phase-shifted sampled sidewall grating. By utilizing linearly chirped sampled gratings and incorporating multiple true π-phase shifts within a cavity, we achieved and experimentally validated a four-wavelength laser with a channel spacing of 0.4 nm. The device operates stably and uniformly across a wide range of injection currents from 280 mA to 350 mA. The average wavelength spacing was measured at 0.401 nm with a standard deviation of 0.0081 nm. Additionally, we demonstrated a 0.3 nm MW-DFB laser with a seven-channel output, achieving a wavelength spacing of 0.274 nm and a standard deviation of 0.0055 nm. This MW-DFB laser features a ridge waveguide with sidewall gratings, requiring only one metalorganic vapor-phase epitaxy (MOVPE) step and a single III–V material etching process. This streamlined fabrication approach simplifies device manufacturing and is well-suited for dense wavelength division multiplexing (DWDM) systems.
15 July 2024 in IEEE Journal of Selected Topics in Quantum Electronics
We have developed a series of dual-wavelength DFB lasers (DWLs) based on different sidewall grating designs. These include DWLs utilizing uniform Bragg gratings (UBG), conventional sampled Bragg gratings (C-SBG), two-phase shifted sampled Bragg gratings (2PS-SBG), and four-phase shifted sampled Bragg gratings (4PS-SBG) for THz signal generation. Additionally, we have explored the use of 4PS-SBG combined with equivalent chirp technology, lateral modulation of the grating coupling coefficient κ, and four-phase-shifted sampled Moiré gratings (4PS-SMG) for millimeter-wave (MMW) signal generation. All the DWLs were fabricated in the AlGaInAs/InP system operating around 1550 nm. For DWLs using UBG, even employing e-beam lithography at its resolution limit of 0.5 nm, the smallest frequency separation is constrained to approximately 400 GHz. C-SBG designs allow precise control of the frequency separation, down to 1.1 GHz, but the effective grating coupling coefficient is only 1/π of that of UBG. Utilizing 2PS-SBG technology can automatically produce DWLs while maintaining the same sampling periods on both sides of the ridge waveguide. The 4PS-SBG demonstrates a higher effective κ (approximately 0.9x that of UBG) compared to the 2PS-SBG (approximately 0.64x that of UBG). To ensure single longitudinal mode operation and mitigate longitudinal mode competition, an equivalent π phase shift (EPS) is inserted at 1/3 of the DFB cavity length on one side, and another EPS is placed at 2/3 of the DFB cavity length on the opposite side. Using equivalent chirp methodology, the two peaks of the photon distributions of the two lasing modes are separated, significantly reducing the overlap region and ensuring stable dual-wavelength operation. Moreover, the wavelength separation can be adjusted by changing the chirp rate. Lateral modulation of the grating coefficient κ allows tuning of the dual-wavelength separation by adjusting the DWL cavity length and the κ value. We show that 4PS-SMG exhibits perfect apodization with a cosine profile and two π phase shifts in the cavity, eliminating the need for intentional insertion of two π phase shifts in the DWL cavity to achieve dual-wavelength operation. All the aforementioned DWLs serve as compact pumping sources for generating THz/MMW signals.
17 January 2023 in Journal of Lightwave Technology
A monolithic dual-wavelength DFB laser array based on sidewall gratings and a novel modulation of the grating coupling coefficient is proposed and demonstrated experimentally. The grating coupling coefficient distribution along the cavity is modulated by changing the alignment between the gratings on the two sidewalls. The frequency difference between the two lasing modes can be modulated by changing the cavity length and grating recess depth. A series of microwave signals in the range of 50 GHz to 59 GHz is observed after beating the two optical lines in a photodetector. The measured optical linewidths are 250 kHz and 850 kHz when the cavity length is 1200 μm and 1000 μm, respectively.
10 January 2025 in Optics Letters
This study proposes and experimentally demonstrates a distributed feedback (DFB) laser with a distributed phase shift (DPS) region at the center of the DFB cavity. By modeling the field intensity distribution in the cavity and the output spectrum, the DPS region length and phase shift values have been optimized. Experimental comparisons with lasers using traditional π-phase shifts confirm that DFB lasers with optimized DPS lengths and larger phase shifts (up to 15π) achieve stable single longitudinal mode operation over a broader current range, with lower threshold current, higher power slope efficiency, and a higher side mode suppression ratio (SMSR). Furthermore, the minimum optical linewidth is reduced significantly, from 1.3 MHz to 220 kHz.
12 June 2024 in Optics Letters
We propose and experimentally demonstrate a dual-wavelength distributed feedback (DFB) laser array utilizing a four-phase-shifted sampled Bragg grating. By using this grating, the coupling coefficient is enhanced by approximately 2.83 times compared to conventional sampled Bragg gratings. The devices exhibit a stable dual-mode lasing achieved by introducing further π-phase shifts at 1/3 and 2/3 positions along the cavity. These devices require only one stage of lithography to define both the ridge waveguide and the gratings, mitigating issues related to misalignment between them. A dual-wavelength laser array has been fabricated with frequency spacings of 320 GHz, 500 GHz, 640 GHz, 800 GHz, and 1 THz. When integrated with semiconductor optical amplifiers, the output power of the device can reach 23.6 mW. Furthermore, the dual-wavelength lasing is maintained across a wide range of injection currents, with a power difference of <3 dB between the two primary modes. A terahertz (THz) signal has been generated through photomixing in a photoconductive antenna, with the measured power reaching 12.8 µW.
19 May 2025 in Optics Express
We demonstrate, for the first time to the best of our knowledge, a monolithic multi-wavelength mode-locked distributed feedback (DFB) laser based on waveguide Bragg grating microcavities, achieving simultaneous three-wavelength lasing near 1.55 μm within a single cavity. The device exhibits a uniform free spectral range of 0.46 nm (57.4 GHz), a side mode suppression ratio exceeding 30 dB, and near-transform-limited pulses (6.25 ps, time-bandwidth product = 0.359). The structure requires only one metalorganic vapor phase epitaxy growth and a single III-V material dry etching step, significantly simplifying fabrication and enhancing reproducibility. By halving and doubling the central cavity length, we also demonstrate dual- and six-wavelength operation with free spectral ranges of 0.75 nm and 0.27 nm, respectively highlighting the design versatility in tailoring the channel count and repetition frequency. This compact platform enables seamless photonic integration with semiconductor optical amplifiers, electroabsorption modulators, and other on-chip components, making it suitable for dense wavelength division multiplexing, coherent optical communications, and photonic sensing.