31 July 2023 in IEEE Transactions on Geoscience and Remote Sensing
Circular synthetic aperture radar (CSAR) offers multi-angle scattering for strong directional targets, benefiting urban surveying. However, the CSAR three-dimensional (3D) imaging of buildings is difficult. The reference height mismatch problem during imaging can lead to a defocused target, and a significant layover phenomenon exists in urban environments. To solve these problems and realize the CSAR 3D imaging of buildings, this study adopts the airborne circular flight array synthetic aperture radar (CFASAR) system for data acquisition and proposes a 3D processing method for airborne CFASAR based on layered phase compensation in the wavenumber domain. CFASAR has advantages over single-baseline and multi-baseline CSAR, as 3D imaging is independent of target azimuth scattering consistency and reduces flight experiment complexity. 3D imaging of buildings consists of two key steps: layered focusing based on phase compensation in the wavenumber domain and super-resolution imaging, which solves the defocusing problem and contributes to high-dimensional resolution. Compared with the traditional layered back projection (BP) imaging, the layered focusing method based on phase compensation in the wavenumber domain has a lower computational complexity. Layered focusing combined with super-resolution processing effectively suppresses conical sidelobes, addresses layover issues, and establishes an accurate 3D scattering model. The proposed method was validated using X-band airborne CFASAR data obtained in Rizhao, Shandong Province, China, in 2021. The experimental results indicate that the proposed method has low time complexity, and it can effectively suppress the conical sidelobe of CSAR and realize high-quality 3D reconstruction of buildings.
20 October 2022 in IEEE Transactions on Geoscience and Remote Sensing
Airborne multiantenna synthetic aperture radar (SAR) urgently needs the high-precision motion information of each antenna to realize high-precision imaging. Distributed position and orientation system (POS) is an important way to solve this problem based on transfer alignment. Because multiple antennas are usually installed on the flexible and discontinuous structure, there are complex and time-varying relative motions between different antennas. This relative motion will lead to the decline of transfer alignment accuracy and directly affects the imaging accuracy of SAR. To solve this problem, a motion information acquisition algorithm of multiantenna SAR installed on flexible and discontinuous structure based on distributed POS is given. First, the gyroscopes and accelerometers of the distributed POS are used to calculate the relative attitude between nodes, which is applicable to both continuous and discontinuous structure. Second, combining the smooth estimation and the distributed filter, a distributed smoothing algorithm including forward filter and backward smoothing is proposed to calculate the high-precision and smoothed motion data of each subnode. The forward filter obtains the motion parameters of each subnode through transfer alignment based on the above relative attitude data. The backward smoothing further improves the motion information accuracy of subnode by using the measurement data at all time and sharing the data of all nodes. Through the flight imaging test of multiantenna SAR installed on a flexible and discontinuous platform, it is shown that the proposed algorithm can significantly improve the accuracy of the subnode motion data, in which the errors of position, velocity, and attitude are reduced by 58.9%, 61.9%, and 71.2%, respectively. Based on this motion data, SAR achieves better imaging focusing effect.