The design, modeling, micro-fabrication, and characterization of an ultra-broadband Ge-on-Si waveguide polarization rotator are presented. The polarization rotator is based on the mode evolution approach where adiabatic symmetric and anti-symmetric tapers are utilized to convert from the fundamental transverse magnetic to electric mode. The device is shown to be extremely fabrication tolerant and simple to fabricate. The fabricated devices demonstrate a polarization extinction ratio of ≥15 dB over a 2 μm bandwidth (9–11 μm wavelength) with an average insertion loss of <1 dB, which is an order of magnitude improvement compared to previously demonstrated devices. This device will provide polarization flexibility when integrating quantum cascade lasers on-chip for mid-infrared waveguide molecular spectroscopy.
24 March 2009 in IEEE Photonics Technology Letters
Optical injection locking and cavity enhanced four-wave mixing in semiconductor ring lasers have been used to generate data modulated millimeter (mm)-wave optical signals. The scheme is shown to have multigigahertz (multi-GHz) modulation bandwidth. The 4-Gb/s data is transferred directly from an intensity modulated optical signal onto an mm-wave optical signal with the mm-wave frequency tunable in steps of 62.5 GHz and with flexible radio-frequency modulation formats over the optical carrier. Bit-error-rate and eye-diagram measurements confirm excellent signal quality.
The integration of nanophotonic optical phased arrays (OPA) with alkali vapor cells has the potential to enhance the performance of chip-scale atomic systems by enabling novel methods for beam shaping and active alignment in atomic spectroscopy. In this work, we present the first demonstration of an OPA used for precision saturated absorption spectroscopy with a rubidium vapor cell integrated directly on the chip. The OPA, consisting of 64 emitters, expands a sub-micron waveguide mode into a >100 µm diameter free-space beam, optimized for the D2 absorption line of rubidium. We resolved the sub-Doppler hyperfine splittings in both 85Rb and 87Rb isotopes, achieving Lorentzian linewidths ranging from 25 to 40 MHz suitable for stabilizing the cooling lasers in rubidium cold atom systems.
A new epitaxial layer design with a double mode expander layer, high refractive index claddings, and an aluminum-free active area has been used to demonstrate distributed feedback lasers operating at 778.1 nm wavelength with reduced Lorentzian linewidth aimed at miniature atomic clock applications. The design also reduces the vertical beam divergence to improve the modal matching with optical fibers as well as maintain the high power output and reduce the emission linewidth. The lasers demonstrate single-mode operation with an over 35 dB side-mode suppression ratio, a power output ≤58 mW, a coupling efficiency to tapered fibers ≤40%, and a Lorentzian linewidth of 3.7 kHz. The performance allowed the free-running distributed feedback lasers to demonstrate spectroscopy of Rb vapor, which resolved the 85Rb and 87Rb two-photon transitions.
We experimentally and theoretically study the characteristics of semiconductor ring lasers bidirectionally coupled by a single bus waveguide. This configuration has, e.g., been suggested for use as an optical memory and as an optical neural network motif. The main results are that the coupling can destabilize the state in which both rings lase in the same direction, and it brings to life a state with equal powers at both outputs. These are both undesirable for optical memory operation. Although the coupling between the rings is bidirectional, the destabilization occurs due to behavior similar to an optically injected laser system.
Semiconductor ring lasers have been designed and integrated with auxiliary coupled optical circuits to beat together the contra-rotating modes. The Sagnac effect predicts a beat frequency proportional to rotation rate, although no beat frequency has yet been observed. Calculations from theory predict a high lock-in frequency; improvements to the design and fabrication of the devices should reduce the lock-in frequency to a useful level.