We have designed, fabricated, and characterized a fiber-optic three-dimensional vector accelerometer for vibration measurement. The accelerometer is based on fiber Bragg gratings (FBGs) inscribed with three cores of seven-core fiber by femtosecond laser with a phase mask. Through monitoring the wavelength shifts of two of the seven cores, we obtain the vibration azimuthal angle and the acceleration in the XY plane by angle reconstruction and algorithmic calculation. Similarly, by monitoring the wavelength shift of the core fixed along the Z-axis, we obtain the vibration acceleration in the Z-axis direction. The full 3D vector information about the vibration signal is obtained by vector synthesis. The accelerometer has achieved a working frequency bandwidth from 10 to 220 Hz with the maximum sensitivity of 355 pm/g, and the best azimuthal angle accuracy of 0.269 ° in the linear range of 0 ° -100 ° and 170 ° -280 ° . Moreover, it is possible to increase the overall bandwidth, sensitivity and accuracy of the azimuth of sensors in the XY plane by adjusting the length of the optical fiber and adjusting mechanical parameters to increase the bandwidth and sensitivity of the sensor in Z-axis. Such improvements will further enhance application to small-scale seismic surveys.
We propose an elliptical spring based 3-axis fiber Bragg grating (FBG) accelerometer fabricated by appropriately arranging and encapsulating three identical 1-axis sensing structures in a cylindrical shell. The derived theoretical equations and the established simulation model of the sensing structure are in good agreement with the experimental results. Sensors on three axes operate in a frequency band of 10-70 Hz; the sensitivities of the proposed accelerometer in X,Y and Z directions are 1197.82 pm/g, 1157.78 pm/g and 1223.04 pm/g respectively, showing high sensitivity, good consistency, directional response and resistance to transverse interference.
A phase demodulation system with a 3 × 3 coupler and active ellipse fitting algorithm for 3C interferometric fiber optic geophone array is proposed. Additional phase modulation is introduced to solve the problem of EFA fitting errors in weak signals. A stable Lissajous is provided for the EFA algorithm to ensure that the ellipse parameters can be calculated at any time. It is experimentally demonstrated that the system exhibits a noise base level of -92.61 dB and a total harmonic distortion of $1.53 \times 10^{-3}$ . The system achieves common mode noise suppression by incorporating a reference sensor, thereby mitigating the impact of field noise on the demodulation process. In the field tests, the proposed system successfully demodulated all phases from a fiber-optic geophone array simultaneously while observing time-of-flight delays and seismic wave frequencies.
10 September 2024 in Journal of Lightwave Technology
In this paper, we propose and demonstrate a method for enhancing the sensitivity of accelerometers using a thin-cladding weak fiber Bragg grating (WFBG) array. Compared to a 125 $\mu \mathrm{m}$ cladding diameter single-mode fiber (SMF), a thin-cladding fiber (TCF) will produce greater deformation for the same force, resulting in a significant increase in the phase change of the transmitted light. The enhanced sensitivity was verified using a 60 $\mu \mathrm{m}$ diameter SMF in a spring-mass accelerometer structure. The accelerometer has an operating bandwidth of 10 Hz to 400 Hz and a sensitivity of 284.96 rd/g (49.09 dB, ref rad/g), which represents a 9.92 dB increase in sensitivity compared to a 125 $\mu \mathrm{m}$ diameter SMF with a sensitivity of 90.87 rd/g (39.17 dB). The proposed sensitivity enhancement scheme is applicable to almost all interferometric fiber optic accelerometers and offers significant advantages in large-scale quasi-distributed oil and gas exploration and monitoring.