5 October 2018 in Scientific Reports
In this paper, we investigate the possibility of improving efficiency in non-radiative wireless power transfer (WPT) using metasurfaces embedded between two current varying coils and present a complete theoretical analysis of this system. We use a point-dipole approximation to calculate the fields of the coils. Based on this method, we obtain closed-form and analytical expressions which would provide basic insights into the possibility of efficiency improvement with metasurface. In our analysis, we use the equivalent two sided surface impedance model to analyze the metasurface and to show for which equivalent surface impedance the WPT efficiency will be maximized at the design frequency. Then, to validate our theory, we perform a full-wave simulation for analyzing a practical WPT system, including two circular loop antennas at 13.56 MHz. We then design a metasurface composed of single-sided CLSRRs to achieve a magnetic lensing based on the calculated equivalent surface impedance. The analytical results and full-wave simulations indicated non-radiative WPT efficiency improvement due to amplifying the near evanescent field which can be achieved through inserting the proposed metasurface.
1 March 2021 in IEEE Transactions on Antennas and Propagation
This paper presents the design of a Huygens’ metasurface (HMS) coating aiming to achieve strongly enhanced invisibility. An analytical formulation for obtaining the required electric surface admittance and magnetic surface impedance is presented. The proposed unit cell consists of a pair of splitrin resonators in the top layer and a metal capacitor in the bottom layer of the same substrate. The geometries are properly designed to provide the required electric surface admittance and magnetic surface impedance for maximum scattering reduction at the operational frequency of 4 GHz. The designed HMS is optimized to realize the required electric surface admittance and magnetic surface impedance for remarkable cloaking purposes. Scattering-cross section (SCS) of uncloaked and cloaked conducting cylinders is obtained with CST Microwave Studio simulation which matches the analytical results. The results show robust scattering reduction with considerable bandwidth for the covered cylinder by the HMS. Furthermore, the obtained results with HMS are compared with the results presented in the literature for cloaking with ordinary metasurface. This comparison emphasizes a much better cloaking performance of the HMS. Considerable cloaking obtained in this paper can be applied for invisibility purposes, sensing applications, antenna isolation, radiation blockage reduction in antennas, eta.
1 April 2017 in AEU - International Journal of Electronics and Communications
2 September 2020 in IET Microwaves, Antennas & Propagation
This study presents a broadband metasurface harvester with polarisation‐insensitive and high harvesting efficiency. The proposed metasurface constitutive main cell consists of two intertwined modified inner and outer Jerusalem cells with two combined different resonance frequencies to obtain a broadband bandwidth. The parameters of the proposed cell are optimised to capture the energy of ambient electromagnetic waves with the least possible return loss and deliver it to the resistive loads through optimally positioned vias. The optimum load resistance value for the proposed harvester is . The simulation results obtained from CST Microwave Studio solver show relative band width of from to 10.5 GHz for different polarisation angles under a normal incident plane wave. Finally, an array of cells of the proposed harvester has been fabricated and its electromagnetic properties have been measured which show good agreement with the simulation results.
9 February 2023 in IEEE Transactions on Antennas and Propagation
Huygens metasurfaces (HMSs) are two-dimensional structures exhibiting both electric and magnetic responses. In this paper, the properties of a parallel-plate waveguide (PPW) formed by two dispersive reactive HMSs are investigated analytically by deriving the dispersion relations for supported surface waves. In particular, the PPWs formed by non-dispersive HMSs are studied thoroughly and it is shown that they can support a maximum of four modes with a variety of transverse electric (TE) and transverse magnetic (TM) degenerate modes, modes with the same cutoff frequencies, and modes with constant phase and group velocities. Such explored PPWs offer degenerate modes with orthogonal polarizations with potential applications in leaky wave antennas and holographs. Moreover, PPWs with either non-dispersive or dispersive borders support modes with subluminal phase velocities which find applications in device miniaturization. The proposed analytical derivations are verified by full-wave numerical simulations.
30 November 2020 in IEEE Access
In this paper, we investigate the electromagnetic response of a Huygens’ metasurface (HMS) embedded between the transmitter and receiver coils of a near field wireless power transfer (WPT) system and their interactions for the feasibility of increasing efficiency. To analyze the proposed configuration, we use the point-dipole approximation to describe the electromagnetic fields and boundary conditions governing HMS to calculate the mutual inductance between the coils and to obtain closed-form analytical expressions. The proposed theory shows that by optimally designing the HMS inclusions, the amplitude of the mutual inductance between the transmitter and receiver coils in the near-field WPT can be increased, resulting in improved efficiency. Finally, by drawing on the proposed theory, we design a thin layer and finite-size HMS consisting of 64 elements. The bianisotropic Omega-type particle is used to design the HMS to improve the efficiency of the sample WPT system at the frequency of 100 MHz. The results of the full-wave simulation show that the power transfer efficiency in the free space increases from 25% to 42% in the presence of the proposed HMS.