Queensland Micro- and Nanotechnology Centre, Griffith University, Brisbane, QLD 4111, Australia, and also with the School of Engineering and Built Environment, Griffith University, Brisbane, QLD 4111, Australia
Auto-generated profile, based on publicly available information
Jordan R. Nicholls
Queensland Micro- and Nanotechnology Centre, Griffith University, Brisbane, QLD 4111, Australia, and also with the School of Engineering and Built Environment, Griffith University, Brisbane, QLD 4111, Australia
Attempts to model the current through Schottky barrier diodes using the two fundamental mechanisms of thermionic emission and tunnelling are adversely impacted by defects and second order effects. This has led to the publication of countless different models to account for these effects, including some with non-physical parameters. Recently, we have developed silicon carbide Schottky barrier diodes that do not suffer from second order effects, such as excessive leakage, carrier generation and recombination, and non-uniform barrier height. In this paper, we derive the foundational current equations to establish clear links between the fundamental current mechanisms and the governing parameters. Comparing these equations with measured current–voltage characteristics, we show that the fundamental equations for tunnelling and thermionic emission can accurately model 4H silicon carbide Schottky barrier diodes over a large temperature and voltage range. Based on the obtained results, we discuss implications and misconceptions regarding barrier inhomogeneity, barrier height measurement, and reverse-bias temperature dependencies.
12 February 2019 in IEEE Transactions on Electron Devices
The low channel-carrier mobility in commercial SiC MOSFETs has been attributed to fast electron traps labeled ``NI.'' These traps exhibit anomalous behavior compared to other interface trap signals. Furthermore, the electrical parameters extracted from a conventional interface trap analysis of the NI signal are not physically reasonable. To explore the origin of these traps, we fabricated SiC MOS capacitors and measured the conductance across a range of temperatures (between 50 and 300 K). By analyzing the surface electron density at the signal peaks, it is evident that these traps are in fact near-interface traps (NITs)--they are located within the oxide and exchange electrons via a tunneling mechanism. We also developed a model for the conductance generated by NITs and demonstrated a good fit to the experimental data. The knowledge that the NI signal is due to NITs will help in directing future efforts to improve SiC MOSFET performance.
We develop ultraviolet (UV) light emitting diodes (LEDs) that operate in the sub-240 nm (far UVC) regime. The traditional limitations of high Al content AlGaN—the low light extraction efficiency due to transverse magnetic polarization and the poor doping efficiency—were overcome by using AlN:GaN short period superlattices (SPSLs) of varying compositions throughout almost the entire device structure. The quality of our molecular beam epitaxy process for growing SPSL devices was verified via transmission electron microscopy and x-ray diffraction—together, these demonstrate our capacity for growing high quality interfaces with a great deal of control over the thicknesses of each individual layer. Resistivity measurements of our SPSL were three times smaller than bulk AlGaN of similar composition due to the improved doping efficiency. Devices fabricated on 6 in. sapphire substrates showed uniform performance, leading to over 10 000 functional devices per wafer. Packaged diodes exhibited a peak wall plug efficiency of 0.55% and an output power of 1.7 mW when operated at peak efficiency. The devices had an operating life (70% initial power) of 2800 h (at 20 mA continuous wave). Additionally, they could be driven as high as 1 A, which resulted in a record for radiant flux of a far UVC LED grown on sapphire (17.4 mW).
Analysis of the switching losses in a power MOSFET is crucial for the design of efficient power electronic systems. Currently, the state-of-the-art technique is based on measured drain current and drain-to-source voltage during the switching intervals. However, this technique does not separate the switching power due to the resistance of the MOSFET channel and due to the parasitic capacitances. In this paper, we propose a measurement method to extract the power dissipation due to the parasitic capacitances of a MOSFET, providing useful information for device selection and for the design of efficient power electronic systems. The proposed method is demonstrated on a basic boost converter. The proposed method shows that the existing method underestimates the turn-On losses by 41% and overestimates the turn-Off losses by 35%.
Fast near-interface (NI) traps have recently been suggested to be the main cause for poor inversion channel mobility in nitrided SiC metal-oxide-semiconductor-field-effect-transistors. Combining capacitance, conductance, and thermal dielectric relaxation current (TDRC) analysis at low temperatures of nitrided SiC MOS capacitors, we observe two categories of fast and slow near-interface traps at the SiO2/4H-SiC interface. TDRC reveals a suppression of slow near-interface traps after nitridation. Capacitance and conductance analysis reveals a high density of fast NI traps close to the SiC conduction band edge that are enhanced by nitridation. The very fast response of NI traps prevents them from detection using TDRC or deep level transient spectroscopy.